Insignia NS-CMKC01 Quick Setup Manual

IMPORTANT
SAFEGUARDS
When using electrical appliances, especially when children
are present, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, or injury to
persons, including the following:
1 Read all Instructions.
2 Do not touch hot surfaces. Use handles or knobs.
3 To protect against fire, electric shock and injury to
persons do not immerse the cord, plug, or coffee maker
in water or other liquid.
4 Close supervision is necessary when your coffee maker is
used by or near children.
5 Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking off parts and
before cleaning.
6 Do not use any appliance if it is damaged (including a
damaged cord or plug) or if it malfunctions. Return the
appliance to an authorized service facility for repair or
adjustment.
7 The use of accessory attachments not recommended by
the appliance manufacturer may result in fire, electric
shock, or injury.
8 Do not use outdoors.
9 Do not let cord hang over edge of table or counter, or
touch hot surfaces.
10 Do not place on or near a hot gas or electric burner, or in
a heated oven.
11 Extreme caution must be used when moving your coffee
maker if it contains hot coffee or water.
12 Do not use the coffee maker for anything other than
intended use.
13 To disconnect, unplug the power cord from power outlet.
14 Scalding may occur during the brewing process if your
coffee maker is not assembled or operated properly. Do
not attempt to open the top cover during the brewing
process or in the few seconds following the completion
of brewing.
15 Fill your coffee maker's water reservoir with water only.
Do not fill with other liquids or foods, except when
following the specific instructions in this guide for
descaling or cleaning the machine.

SAVE THESE INSTRUCTIONS

Before using your new product,
please read these instructions to prevent any damage.
POLARIZED PLUG
Your coffee maker is for HOUSEHOLD USE ONLY. It may be
plugged into an AC power outlet (ordinary household
current). Do not use any other power outlet.
Your coffee maker has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the plug and try
again. If it still does not fit, contact a qualified electrician. Do
not attempt to modify the plug in any way.
Power cord safety tips
• Your coffee maker comes with a short power-supply cord
to reduce the risk of becoming entangled in or tripping
over a longer cord. Extension cords are available and may
be used if care is exercised in their use. If an extension
cord is used:
• The marked electrical rating of the cord set or
extension cord should be at least as great as the
electrical rating of your coffee maker.
• The cord should be arranged so that it does not hang
over the counter top or tabletop where it can be
pulled on by children or tripped over unintentionally.
• Never pull or yank on the power cord on your coffee
maker.
• To insert the plug, grasp it firmly and guide it into the
power outlet.
• To disconnect your coffee maker, grasp the plug and
remove it from the power outlet.
• Before each use, inspect the line cord for cuts or abrasion
marks. If any are found, this indicates that your coffee
maker should be serviced and the power cord replaced.
• Never wrap the power cord tightly around your coffee
maker, because this could place undo stress on the cord
where it enters your coffee maker and cause the cord to
fray and break.
Caution: There are two sharp needles that puncture the
K-Cup® capsule. One is located in the top cover of the brew
chamber and the other is in the bottom of the K-Cup® capsule
holder itself. To avoid risk of injury, do not put your fingers in
or near the K-Cup® capsule assembly housing.
Caution: The water in the K-Cup® capsule holder is extremely
hot during the brewing process. To avoid risk of injury, do not
press the brew chamber release button or open the top cover
during the brewing process.
PACKAGE CONTENTS
• Single-serve coffee maker
• Water reservoir filter
• Brew basket
• K-Cup® capsule holder
• Drip tray with cover
• Quick Setup Guide
FEATURES
• One-touch control
• Removable K-Cup capsule holder
• Removable brew basket
• Removable drip tray
• Brews up 14-ounces of coffee
Brew chamber Flip-top
release button water reservoir
Brew basket
(inside brew
chamber)
Brew spout
Capsule brew
button
Ground coffee
brew button
Drip tray cover
Removable
drip tray
Quick Setup Guide |
NS-CMKC01
Insignia Single-Serve Coffee Maker
UNPACKING YOUR COFFEE MAKER
1 Carefully unpack your coffee maker and all parts. Remove
any tape, labels, or packaging materials.
2 Wash the water reservoir filter, drip tray, drip tray cover,
K-Cup® capsule holder, and brew basket with warm, soapy
water. Rinse well and dry thoroughly.
Note: You can wash the water reservoir filter, drip tray, drip
tray cover, K-Cup® capsule holder, and brew basket in a dish
washer. Place the parts on the top rack and use a low
temperature cycle.
3 Wipe the exterior surfaces of your coffee maker with a soft,
moist cloth to remove dust particles collected during
packing and handling. NEVER immerse your coffee maker,
power cord, or plug in water or any other liquid.
4 Place your coffee maker on a solid, level, heat-resistant
surface.
BEFORE USING
Before you use your coffee maker for the first time, we
recommend that you pre-clean it by running the brew cycle
using water only.
Note: During the first few minutes of initial use, you may notice
smoke or a slight odor. This is normal and should quickly
disappear. It will not recur after you have used your coffee
maker a few times.
To pre-clean your coffee maker:
1 Place the water reservoir filter in the water reservoir.
2 Fill the water reservoir to the maximum level, then close the
lid.
3 Place the brew basket in place. DO NOT insert the K-Cup
capsule holder.
4 Close the top cover on your coffee maker.
5 Place a large cup or mug on the drip tray, beneath the brew
spout.
6 Plug the power cord into a power outlet.
Note: Ideally, your coffee maker should be operated on its
own circuit, separate from other appliances to avoid
overloading the circuit.
7 Press the GROUND button. Your coffee maker heats, then
dispenses the water.
8 After the water is done brewing, your coffee maker
automatically shuts off and is ready to use.