Specific Safety Precautions; Tool Use And Care - Power first 18V Impact Driver User Manual

V 2.0
• Do not charge the Battery Cartridge when temperatures are below 10°C (50°F) or above 40°C (104°F).
• Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
• Do not allow anything to cover or clog the charger vents.
• Always cover the battery terminals with the battery cover when the battery cartridge is not used.
• Do not short the battery cartridge:
1. Do not touch the terminals with any conductive material.
2. Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.
3. Do not expose battery cartridge to water or rain.
NOTE: A battery short can cause a large current flow, overheating the unit and possible burns and even a
breakdown could occur.
• Do not incinerate the Battery Cartridge even if it is severely damaged or is completely worn out. The battery
cartridge can explode in a fire.
• Do not store the tool and battery cartridge in locations where the temperature may reach or
exceed 50°C (122°F).
• Be careful not to drop, shake or strike the battery.
• Do not charge inside a box or container of any kind. The battery must be placed in a well ventilated area
during charging.

SPECIFIC SAFETY PRECAUTIONS

• Be aware that this tool is always in an operating condition, because it does not have to be plugged into an
electrical outlet.
• Check the socket carefully for wear, cracks or damage before installation.
• The proper fastening torque may differ depending upon the kind or size of the bolt. Check the torque with a
torque wrench.
• Do not over-tighten nuts. They could shatter and cause damage to the tool or work piece or cause serious
injury. Use a torque wrench to torque the nut after using the impact wrench.
• Do not use any additional force upon the wrench in order to remove a nut.
• Do not allow the wrench to run without load for an extended period of time as this will shorten its life.
• SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for the
battery charger.

TOOL USE AND CARE

1. Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger
industrial tool. The tool will perform better and more safely at the task for which it was intended. Do not
modify this tool or use for a purpose for which it was not designed.
2. Securely hold this tool using both hands. Using tools with only one hand can result in loss of control.
3. Maintain tools with care. Keep tools clean, and in good condition for a better and safer performance. Follow
instructions for lubricating and changing accessories. Inspect tool fittings and alignment periodically and, if
damaged, have them repaired by an authorized technician or replaced. The handles must be kept clean, dry
and free from oil and grease at all times. A properly maintained tool reduces the risk of binding and is easier
to control. Applying excessive force can lead to slips and damage to your work or personal injury.
4. Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed from the tool or
machine before connecting it. A wrench or key that is left attached to a rotating part of the tool increases the
risk of personal injury.
5. Avoid unintentional starts. Be sure that the ignition switch is in neutral or OFF position when not in use and
before connecting it to any power source. Do not carry the tool with fingers near or on the switch.
6. Only use the lubricants supplied with the tool or specified by the manufacturer. Other lubricants may not be
suitable and may damage the tool or even make the tool explode.
7. When not in use for an extended period, apply a thin coat of lubricant to the steel parts to avoid rust.
8. Maintain the label and name plate on the tool. These carry important information. If unreadable or missing,
contact Princess Auto for a replacement.
6
18V Impact Driver
For technical questions call: 1-800-665-8685
8384455