Kenwood KDC-MP632U Instruction Manual page 40

Connecting Wires to Terminals (KDC-MP632U)
USB connector
Rear left output (White)/Sub
Woofer left output (White)
Rear right output (Red)/Sub
Woofer right output (Red)
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the Kenwood navigation
system, consult your navigation manual.
To car light control switch
To front right speaker
Ignition key switch
Car fuse box
(Main fuse)
+
Battery
40
|
English
To USB device
Front left output (White)
Front right output (Red)
To Kenwood disc changer/ External optional accessory
To front left speaker
To rear left speaker
To rear right speaker
Car fuse box
–
• Do not remove the cap when you do not use the
USB cable. The connector will cause the unit to
malfunction if it gets in touch with any metallic part
of the vehicle.
• Fasten the connector with the tape so that the cable
will not come off.
FM/AM antenna input
To connect these leads, refer to
the relevant instruction manuals.
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
ILLUMI
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
ACC
Ground wire (Black) - (To car chassis)
AUX right input (Red)
AUX left input (White)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)