Vanguard VYS18NWA Owner's Manual page 11

INSTALLATION
Continued
locations in mortar joint of bricks.
8. Remove heater base from fireplace.
9. Drill holes at marked locations using
3/16" drill bit.
10. Attach base assembly to fireplace floor
using two masonry screws (in hardware
package).
Flexible Gas Hose (if
allowed by local codes)
Fitting
Figure 11 - Attaching Flexible Gas Hose
to Heater
Figure 12 - Attaching Base Assembly to
Fireplace Floor
105189
INSTALLING GWMS2
(OPTIONAL) WALL
MOUNTED SWITCH
Items Included for Installation
• Switch
• Switch Cover (With Screws)
• 25 Ft. Wire
Connecting To Log Set
1. Connect one terminal of 25 ft. wire to
bottom contact of switch located on
heater front control panel (see Figure 13).
2. Connect remaining wire terminal to the
"TH" terminal on the control valve (see
Figure 13).
3. Route the 25 ft. wire to a convenient
location.
the switch to a power source.
Electrical shock and/or fire haz-
Masonry Screw
ard will occur.
Mounting
Flanges
OWNER'S MANUAL
WARNING: Do not connect
11
IMPORTANT: The wire may be shortened
but must not be lengthened.
4. Connect one bare wire end to each of
the terminals of the provided wall
switch.
5. Install the wall switch and cover in the
wall.
Switch
One
terminal
To Wall
of 25 ft.
Switch
wire
Wall Switch
Figure 13 - Connecting Wire Terminals
To Wall
Switch
Continued