Table of Contents
Advertisement
2.2.3
Setup
Siemens Building Technologies
Fire Safety & Security Products
Damage due to unsuitable mounting location
Observe the environmental requirements recommended by the manufacturer.
Do not operate the device close to sources of powerful electromagnetic
radiation.
Protect the device against moisture.
Do not operate the device in excessively dusty places.
Do not expose the device to mechanical vibrations or shocks.
Put a shock-absorbing and antistatic material on the desk where the HDD is to
be handled (the antistatic material should be put on top of the shock-absorbing
material).
Do not press on the top of the button of the drive.
Damage to the device due to lack of ventilation
Do not block or cover the ventilation openings of the device.
Damage to the device due to overload
Use only the shielded video interface cable recommended in this document to
ensure compliance with the limits for digital output devices.
Risk of failure of the main device
Power cables to the main device are to be run separately and have a dedicated,
clearly labelled fuse.
Danger of electrical shock due to insufficient labelling
Terminals carrying an external voltage supply must be labelled "DANGER –
external voltage".
Danger of electrical shock and damage to the device
Electrical grounding must meet the customary local safety standards and
regulations.
Handle the drive care fully by the edges. Do not touch the exposed printer circuit
board or any electronic components.
Wear a wrist strap when handling HDD.
Before handling the drive, discharge any static electricity from yourself and your
clothing.
With one hand touch an unpainted metal surface, then touch the ESD bag with
the other hand. Remain in contact with the metal surface and the bag for a
minimum of 2 seconds.
Danger of electrical shock due to incorrect connection
Make sure the device is permanently connected to the electricity supply; a
readily accessible disconnect device must be provided.
Liability claim
For reasons of electromagnetic compatibility RS232, USB, audio in/out and
power supply cables must not exceed 3 meters length.
Safety
7
03.2009
Hide quick links:
Advertisement
Table of Contents
