System Q; Audio Control; Audio Setup; Speaker Setting - Kenwood KDC-3031A Instruction Manual

General features

System Q

You can recall the best sound setting preset for
different types of music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [Q] button.
Each time the button is pressed, the sound
setting switches.
Sound setting
Natural
Rock
Pops
Easy
Top 40
Jazz
• When the System Q setting is changed, the Bass,
Middle, and Treble set in audio control replace the
System Q values.
• "USER" : The values set on the <Audio Control> (page
8).
• Each setting value is changed with the <Speaker
Setting> (page 8).
First, select the speaker type with the Speaker setting.

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4
Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Bass level "BAS L"
Middle level "MID L"
Treble level "TRE L"
Balance "BAL"
Fader "FAD"
8
|
English
Display
"NATURAL"
"ROCK"
"POPS"
"EASY"
"TOP40"
"JAZZ"
Range
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
5
Exit Audio Control mode
Press any button.
Press the button which is not [VOL] knob and
[ATT] button.

Audio Setup

Setting the Sound system, such as Volume offset
and Loudness.
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4
Adjust the Audio setup item
Turn the [VOL] knob.
Adjustment Item Display
Volume offset "V-OFF"
Loudness "LOUD"
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
When it's ON, "LOUD" indicator is ON.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
Range
–8 — ±0
ON/OFF