f) Insert Inner Camera and close housing lid
Insert the inner film camera with the power on and lens open (power switch below the
lens). Make sure the Moisture Muncher or any other matter does not interfere with closing
the housing.
Hold the latch down deep inside the strike
while closing. Do not use force.
Take a test picture. If film does not advance or FLASH READY light does not turn on, see
page 41 for Trouble Shooting Guide.
Power save function:
The power will turn off automatically, when the
camera is not used within about 2 to 3 minutes
and will turn on again by a light touch on the
shutter release.
13