Furuno CSH-5L Installation Manual page 24

1. MOUNTING
Installation without KB fixing plate
1. Make four holes of 6 mm in diameter referring to the figure below.
2. Make an indentation in the desktop to accommodate the nameplate (approx. 2 mm
thickness) at the bottom of the control unit.
3. If necessary, make a hole of 30 mm in diameter in the desktop to pass the control cable
from the bottom of the control unit. To run the cable from the bottom of the control unit,
see the next page.
4. Screw in four hex. bolts (M5x12, supplied as accessories) from the under side of the
table to fix the control unit..
When the supplied bolts are not long enough, use the locally supplied bolts, with their length
the thickness of the desktop plus 5 to 8 mm.
1-16
How to attach KB fixing plate
Control unit, dimensions for directly mounting
Mounting control unit directly
Cable