Network Setup; Dvr Network - Digiguard H.264 Digital video recorder -4/8/16 channel models User Manual

H.264 stand-alone digital video recorder
Table of Contents

Advertisement

7. Network Setup

7-1. DVR Network Setup
Please contact your local network service provider for information below:
- Upload Speed : to predict frame rate via network.
- Download Speed : to predict frame rate via network.
- Addressing : to determine which scenario to follow.
- Router ON Site or Just Modem : to determine which scenario to follow.
* NOTE : If the provider is using PPPoE (usually D니 providers), you MUST have a IP Share installed
on site, and follow 3) Dynamic IP of PPPoE (DSL) for DVR setup and access.
* Verify if Internet accessible after installing any new equipment (routers, switches, modems, etc.)
PC's TCP/IP Setup
Fill out the information below before configuring DVR if applicable:
Choose PC connected to the network and determine its TCP/IP setting.
IP address : __________________________________________________________ ex) 192.168.1.5
Subnet Mask : ________________________________________________________ ex) 255.255.255.0
Default Gateway : _____________________________________________________ ex) 192.168.1.1
Refer to following scenarios 1) ~ 3), and identify which scenario your current network falls within and
follow instructions for configuring and accessing your DVR via TCP/IP.
1) Static IP
User input IP address assigned from ISP company in IP CONFIG SETUP.
1) Verify if IP address is OK with your PC before connecting DVR.
2) Connect static IP LAN cable to DVR after verification.
3) Enter into [MENU]-[NETWORK SETUP]-[IP CONFIG].
4) Select STABLE IP and set assigned IP address.
5) Input GATEWAY assigned from ISP company.
6) Input SUBNET MASK.
7) Exit MENU.
8) Verify if MAC address starts with 00-0A-A2....
9) Set IP port in CONNECTION SETUP. (50000 recommended)
10) Turn off Modem or Router provided by ISP company, and turn on again.
(This process is to reset client's MAC from ISP company. Wait for 30 sec after turning on.)
11) Access DVR with Transmitter Program.
* If access via Transmitter fails, check 1), 5), 6) & 9) again.
44

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents