Logitech KeyCase Setup Manual page 5

General KeyCase
™
1. On the Palm handheld, tap the Home icon to display the Applications Launcher.
®
2. Tap the Logitech icon. After the Setup screen appears, the following hardware settings display. You can customize
each setting by using the stylus to make your selection.
Repeat rate. Sets the rate at which a character is repeated when a key is held down.
Repeat delay. Sets the initial delay after which a character is repeated when a key is held down.
Sensitivity. Sets the sensitivity of the keys in response to the pressure exerted on them when they are pressed.
Test keyboard. Tests the settings you have chosen. Type characters into this field and adjust the settings as necessary.
Key clicks. Sets an audible click each time a key is pressed. Removing the checkmark removes the audible click. (Note that clicks
will not sound if your handheld sound is turned off.)
Keyboard enabled. Enables the keyboard driver. This box must be checked for your KeyCase
Note Each time you reset the Palm
abled" setting. And if you have other non-Logitech
to make sure that these drivers are disabled.
Shortcut Keys
® ™
The Logitech KeyCase features six shortcut buttons to make accessing applications on your Palm
These buttons include Find, Date, Address, To Do, Memo, and Mail. The KeyCase
used commands, such as Done, OK, and Cancel.
Customizing the KeyCase
The Logitech ® software lets you program ten additional shortcuts to the numeric keys. To use these keys after you have programmed
them, press the Screen Button key followed by a numeric key to launch the application that has been assigned to that key. To program
a numeric key, do the following:
™
1. On the Palm handheld, tap the Home icon to go to the Applications Launcher.
®
2. Tap the Logitech icon to display the Setup screen.
3. Tap the Pick List icon (top right of the screen) and select Commands. Ten Command functions will display. Each command
corresponds to a numeric key.
4. Select the Command number you wish to program.
5. Tap the down arrow next to Commands. A list of applications will appear.
6. Tap the application you wish to assign. Repeat this procedure for any other keys you wish to program.
Note In addition to launching application shortcuts, the Screen Button key also provides easy access to on-screen buttons
when used with the letter keys. For more information, see the section "Using the Screen Button keys."
Settings
™
™
handheld, you must re-enable the Logitech
™
English
®
keyboard driver by checking the "Keyboard en-
®
keyboard drivers installed on the handheld, you will also need to check
™
also features one-touch instant access to commonly
™ to work.
™
handheld more convenient.
5