Assembly Instructions - HomComfort Smartfire PG-30 Assembly And Operating Instructions Manual

READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING THE APPLIANCE.
Tools and Materials Needed For Installation:
You will need a #2 phillips screw driver for assembly. Using a drill with a phillips bit will speed the assembly process. Two (2) 7/16"
socket/wrench to install wheels. A 5mm hex drive to install the handles. Use proper assembly technique, when installing bolts start all
bolts fi rst and then tighten appropriately. The assistance of a second person is strongly recommended. You will have to remove the grill
contents for assembly.
STEP 1: BASE AND PEDESTAL ASSEMBLY
1. Attach wheels to base using 1/4-20 bolts, axel, washers and acorn nuts provided. Washers should go between wheels and nuts
2. Assemble the pedestal using the provided bolts and rivet nuts
3. Attach the pedestal to the base using 6 bolts and rivet nuts along the bottom.
4. Attach main grill body to assembled pedestal with 6 bolts and rivet nuts along bottom of grill body.
Acorn Nut
Wheel Installation
Pedestal and Base Assembly
Flat and Lock Washer
Side Table and Handle Installation

ASSEMBLY INSTRUCTIONS

Do NOT remove the Searing Station.
STEP 2: SMOKE STACK ASSEMBLY
1. Install smoke stacks and baffl e in grill lid as shown. (Stack goes up through lid)
The smoke stack uses the 1st set of nuts below the fl ange.
The baffl e uses the 2nd set of nuts above and 3rd set below.
The baffl e should be spaced approximately 7/8" from the top of the grill.
2. Attach smoke pipe fl aps to top of smoke stack.
Smoke Stack
5
Rivet Nut Assembly
1st Nut
Baffl e
Smoke Stack Installation
STEP 3: HANDLES ASSEMBLY
1. Attach front lid handle to grill lid using supplied bolts.
2. Attach side handle to main grill body using supplied bolts.
Insure the beauty rings are on the handle.
Parts List
Description Qty
Pedestal, Right Side 1
Pedestal, Left Side 1
Pedestal, Center 1
Base (PG36) 1
Base (PG30) 1
Caster Wheel 2
Fixed Wheel 2
1/4-20 Bolt x 0.75 32
1/4-20 Nut 18
Split Lock Washer 2
1/4-20 Bolt x 1.25 6
Smoke Stack 2
Side Handle 1
Smoke Stack Flap 2
Bolt
2nd Nut
3rd Nut