Related Manuals for Apex Hi-Fi P2X
Summary of Contents for Apex Hi-Fi P2X
- Page 1 Tube hybrid pre-amp and headphone amp With IR remote control Instructions www.apexhifi.com...
- Page 2 Audio Inputs There are two RCA line inputs located on the back of the P2X, labeled “In 1” and In 2”. There is also a third input, using a 1/8” phone jack, on the left-hand side of the front panel. This is “In 3”, and can be used to connect a phone or music player.
-
Page 3: Input Selection
Operation Power-on and off The P2X is powered on or off by pressing the control in and holding it for 5 seconds. When the unit powers on, it enters a 30-second warm- up period for the tube to heat up and electronics to stabilize. -
Page 4: Remote Control Operation
Remote Control Operation The volume control unit uses Philips RC05 remote control encoding. It is supplied with a small remote that can control all the functions of the unit. If desired, any remote control that supports RC05 codes can be used. Power-on and off The “standby”... -
Page 5: Setup Mode
Setup Mode Setup mode uses the control knob and LEDs to allow Green you to set various operating modes of the P2X. Once you complete setup mode, your choices are saved in Blue non-volatile flash memory, so they will remain until you Cyan change them again. - Page 6 Setup Step 5 - Power-up to On or Off Power-up Off In setup step 5, LED 4 will be illuminated. The color of the LED indicates if the unit should initialize to the Power-up On power-on state when AC power is applied to the unit, or if it should come up in the off state.
Need help?
Do you have a question about the P2X and is the answer not in the manual?
Questions and answers