McCulloch TRIMMAC Operator's Manual
  1. Manuals
  2. Brands
  3. McCulloch Manuals
  4. Lawn Mower
  5. TRIMMAC
  6. Operator's manual

McCulloch TRIMMAC Operator's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

GB Operator!s manual 2-13
SE Bruksanvisning 14-25
DK Brugsanvisning 26-38
FI
Käyttöohje 39-51
NO Bruksanvisningen 52-63
FR Manuel d!utilisation 64-77
NL Gebruiksaanwijzing 78-91
IT
Istruzioni per l!uso 92-105
ES Manual de instrucciones 106-119
DE Bedienungsanweisung 120-133
PT Instruções para o uso 134-147
HU Használati utasítás 148-160
PL
Instrukcja obs ugi 161-174
EE Käsitsemisõpetus 175-187
LV Lieto"anas pam c ba 188-200
LT
Naudojimosi instrukcijos 201-213
SK Návod na obsluhu 214-226
HR Priru nik 227-238
SI
Navodila za uporabo 239-251
CZ Návod k pou#ití 252-264
RO Instruc iuni de utilizare 265-277
BG
278-295
RU
296-307
GR O
TR Kullanõm kõlavuzu 320-332
TRIMMAC
308-319
LT25NCOP

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRIMMAC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for McCulloch TRIMMAC

Summary of Contents for McCulloch TRIMMAC

  • Page 1 CZ Návod k pou#ití 252-264 NL Gebruiksaanwijzing 78-91 RO Instruc iuni de utilizare 265-277 Istruzioni per l!uso 92-105 ES Manual de instrucciones 106-119 278-295 TRIMMAC DE Bedienungsanweisung 120-133 PT Instruções para o uso 134-147 296-307 HU Használati utasítás 148-160 GR O...

  • Page 2: Identification Of Symbols

    IDENTIFICATION (WHAT IS WHAT?) Muffler Manual Assist Handle Locking Sleeve Assembly Shaft Trimmer Head Throttle Trigger Primer Bulb Shield Spark Plug Starter Handle Choke Lever ON/OFF Switch Wrench Fuel Mix Fill Cap IDENTIFICATION OF SYMBOLS WARNING! This trimmer can be dangerous! Careless or improper use can cause serious or even fatal injury.

  • Page 3: Safety Rules

    SAFETY RULES S Dress properly. Always wear safety WARNING: glasses or similar eye protection when op- When using gardening erating, or performing maintenance, on appliances, basic safety precautions should al- your unit (safety glasses are available). ways be followed to reduce the risk of fire and Eye protection should be marked Z87.

  • Page 4: Fuel Safety

    FUEL SAFETY TRANSPORTING AND STORAGE S Mix and pour fuel outdoors. S Allow the engine to cool; secure unit before S Keep away from sparks or flames. storing or transporting in vehicle. S Use a container approved for fuel. S Empty fuel tank before storing or transport- S Do not smoke or allow smoking near fuel or ing the unit.

  • Page 5: Operation

    Upper Locking 1. Remove nut from shield. Sleeve Assembly 2. Insert bracket into slot on shield. 3. Pivot shield until bolt passes through hole in bracket. 4. Reinstall nut and tighten securely with wrench (provided). Shield Bracket Lower Locking Sleeve Assembly NOTE: If locking sleeve assembly will not tighten, the shafts are not fully seated.

  • Page 6: Starting A Cold Engine

    the FULL CHOKE position and press the Starting Position primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the starter rope until the engine runs, but no more than NOTE: 6 pulls.

  • Page 7: Cutting Methods

    S Near objects around which the line can- WARNING: wrap such as small posts, trees or fence Always wear eye protec- wire. tion and hearing protection. Never lean over S For mowing or sweeping, use full throttle for the trimmer head. Rocks or debris can rico- a good clean job.

  • Page 8: Maintenance

    MAINTENANCE NOTE: Do not clean filter in gasoline or other WARNING: Disconnect the spark flammable solvent to avoid creating a fire haz- ard or producing harmful evaporative emis- plug before performing maintenance except for carburetor adjustments. sions. 3. Wash the filter in soap and water. CHECK FOR LOOSE 4.
  • Page 9 Cover Spool 8. Position the lines in the guide slots. Guide slot Guide slot 2. Remove any remaining line. 3. Clean dirt and debris from all parts. Re- place spool if it is worn or damaged. 4. Replace with a pre-wound spool, or re- place line using a 8 meters length of 2 mm diameter line.

  • Page 10: Carburetor Adjustment

    S Engine will not idle when the throttle is re- leased. Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments.
  • Page 11 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not 1. ON/OFF switch in OFF 1. Move ON/OFF switch to ON position. start.

  • Page 12: Declaration Of Conformity

    Husqvarna AB claims sole responsibility for the trimmer and/or brushcutter platform(s) LT25NCOP representing model(s) TRIMMAC from 2013 serial numbers and on-wards. The platform number and model number are clearly stated in plain text on the type plate along with the year with subsequent serial numbers.

  • Page 13: Technical Data Sheet

    TECHNICAL DATA SHEET ODEL: ENGINE Cylinder displacement, cm At maximum engine power, rpm 8000 Maximum rotational frequency of the spindle, rpm 10000 Engine speed at recommended maximum spindle rotational frequency, rpm 10000 Recommended speed idling, rpm 4000 Maximum engine power, measured in accordance with ISO 8893, kW Catalytic converter muffler IGNITION SYSTEM...

This manual is also suitable for:

Lt25ncop

Table of Contents