Connect Headphones; Adjusting The Volume; Memory Card - JVC XA-SD1 Instruction Manual

Sd audio player
Hide thumbs Also See for XA-SD1:
Table of Contents

Advertisement

Playback
Stop playback
I Resume
and turn the
When 3/7 is pressed again after the unit has
unit off.
been turned off, playback resumes from the
position at which the unit was turned off.
However, playback starts from the first track if
the SD memory card is changed or batteries are
removed and inserted again while the unit is off.
Press 3/7.
The unit is turned off automati-
cally in about 10 seconds.
Set to NORM.
HOLD
MODE
NORM
Insert the plug
firmly.
1
Card cover
2
3
To
To
decrease
increase
VOLUME
To remove
the SD

memory card

While playback is stopped, open the card
cover (operations ~ in step 3 above) and
unlock and remove the SD memory card by
pushing its center area.

Connect headphones.

To use an extension cord, see below.
Insert an SD memory card con-
taining data check-out (recording).
~ Slide the card cover on the side of
the unit in the direction of the arrow
and open the card cover.
Open it while pushing the battery com-
partment cover.
Ÿ Hold the SD memory card with the
label side up, then insert the card
from the side having cut corners.
! Insert the SD memory card by
pushing the center of its edge until
it locks, then close the card cover.
Note
Never insert the SD memory card upside
down. Otherwise, it will not be able to be
removed.
Press 3/7.
The unit is turned on and playback starts.
Immediately
after press
Track No.
Approx. 2 sec.
later

Adjusting the volume

Press and hold to vary continuously.
Volume level meter
Volume level (Adjustment range 0 to 25)
Card cover
1
Extension cord
(supplied)
Elapsed play time
Track title

Advertisement

Table of Contents
loading

Table of Contents