Table of Contents
Advertisement
Preparing the power supply
Recharging the Rechargeable Batteries
1
Rechargeable battery: (BN-R1213)
(supplied)
Compartment A
Compartment B
2
To a household
power outlet
Charge indicator lamps
A charging state
Charging
Compartment A
(Fast on-and-off)
Compartment B
(Slow on-and-off)
• If two batteries are inserted in the battery charger that has already been
plugged into the power outlet, the first-inserted battery will be re-
charged first.
• Fast blinking refers to one blink per about 1 second, and slow blinking
refers to one blink per about 3 seconds.
Insert rechargeable nickel metal hydride batteries (BN-R1213, hereinafter referred to as rechargeable batteries) or L30 (24A) alkaline dry cell batteries.
Insert two rechargeable
batteries in the battery
charger.
• Insert them in the correct ª
and · polarity as indicated
inside the battery charger.
• The two batteries will be
recharged separately one after
another.
Insert the power plug blades
into a household power outlet.
• Recharging begins with the
battery inserted in position A. The
recharging of two batteries will
complete in about 4-1/2 hours.
• It is possible to recharge about
300 times.
• After recharging completes,
remove the power plug blades
from the power outlet.
B charging state
Completed
Finished
Finished
(Continuous on)
(Continuous on)
Charging
Finished
(Fast on-and-off)
(Continuous on)
Insert batteries in the Main unit.
Open the battery compartment cover.
1
Card cover
(Open it while pushing the
battery compartment cover.)
Insert batteries.
2
1
2
3
Close the battery compartment cover.
Battery compartment
cover
I Caution for use of dry cell batteries:
Be sure to use L30 (24A) alkaline batteries. Manganese batteries cannot be
used to power the unit.
I Remaining battery power display:
Use the remaining battery power indicator in the display panel as the
reference for identifying the available power.
High
Low
Notes on battery replacement
During recharging of the batteries, use two L30 (24A) alkaline batteries,
which is available in electric appliance stores. The built-in clock display
can be retained by changing the batteries within 30 seconds.
Hold mode
The hold mode protects the unit against accidental press of control buttons.
Battery
compartment
cover
• Insert them in the correct ª
and · polarity as indicated
inside the battery compartment.
(You can use L30 (24A)
alkaline batteries or recharge-
able batteries only.)
Card cover
Blinking
Recharge
(or replace).
It prevents the following acci-
dents:
• Battery exhaustion by turning the
unit on without noticing it.
• Interruption of playback due to
accidental press of a button.
Advertisement
Table of Contents
