Setting Up Your Cell Phone - Jabra M5390 User Manual

4.5
4.5
3.10
4.6
3.11
4.6
3.12 3.13
4.7
4.7
Note: If you can hear your own voice, the outgoing volume is probably too high. Reduce the volume setting on
1)
4.8
your desk phone (if the feature is available) and compensate by increasing the volume on your headset.
6
Setting the outgoing volume
3.10 Make a call (see section 4)
to someone who can act as a test
person.
3.11 Adjust the outgoing volume
using the transmit volume control
on the base unit. Move the switch
through the 3 settings until test
person confirms the appropriate
volume. 1)
Setting the incoming volume
3.12 During a call, adjust incoming
volume by pressing the Volume
button on the headset.
3.13 A tone will be heard to indicate
when min./max. volume is reached.

4. Setting up your cell phone

Setup
Pairing your headset with your cell phone
NOTE: Before use, please charge your headset (see 3.4).
Before using your Jabra M5390 Multiuse headset with a cell phone, you need to pair it with your
cell phone.
•
Make sure the headset is off.
•
During start-up keep pressing the Answer/End button for three seconds. Alternatively remove
the snap-on cover and press the reset button on the headset for three seconds. The visual
indicator on the headset will turn to steady blue. (see 9.1)
•
®
Instruct your phone's Bluetooth to 'discover' the Jabra M5390 Multiuse headset:
o Follow the instructions in your phone's User Manual. This usually involves going to a 'setup,' 'connect'
or 'Bluetooth' menu on your phone and selecting the option to 'discover' or 'add' a Bluetooth
o Your phone will find the Jabra M5390 Multiuse headset and ask if you want to pair with it.
•
Accept pairing by pressing Yes/OK (or similar) on the phone and confirm with the passkey or
PIN '0000' (4 zeros).
•
Your phone will confirm when pairing is complete. If pairing is unsuccessful, repeat the steps
above. Some cell phones require a manual connection to be established after pairing. Note that
on some cell phones, the headset has to be set as "Trusted device".
NOTE: If you accidentally put the headset into pairing mode, tap the Answer/End button to exit
pairing mode.
IMPORTANT: The same headset can be paired with multiple cell phones. However, if you have
multiple cell phones paired, switched on and within range of the headset, the headset will not be able
to connect to the base. It is only possible to be connected to one cell phone and the headset base at
a time. To be able to connect to the headset base, only have one paired cell phone may be turned on
and within range of the headset.
®
device.
7