Drainage; By The Supplied Water Tray; By Water Tube (Continuous Drainage) - Amcor AMB12KE410A Instruction Manual

Drainage

During the process of cooling, some water
will be extracted from the air into the unit. If
the water container inside the unit is full, the
unit will stop, the fan will continue to circulate
the air. The POWER-LED will blink to inform you
to empty the internal container. To make the
cooling function work again, please empty the
water by one of the following methods:

By the supplied water tray.

1. Turn OFF the unit.
2. Position the supplied plastic water tray flat
on the floor under the drain hole.
3. Remove the drain knob and the rubber plug
from the drain hole. The condensed water will
drain out automatically.
4. When the water tray is almost full, replace
the rubber plug into the drain hole to stop the
water. Empty the water tray.
Rubber plug Drain knob Water tray
5. Repeat steps 2, 3 and 4 until all the
condensed water is emptied.
6. One all the condensed water has been
removed, replace the rubber plug into the
drain hole firmly. The 'Tank Full' indicator
should be off now.
7. Replace the drain knob.

By water tube (continuous drainage)

1. Remove the drain knob and rubber plug
and keep them for future use.
2. Connect the supplied water tube to the
water hole. The condensed water will drain
out automatically.
3. If you want to extend the water tube, you
can connect it with another tube (outside
diameter 18 mm).
8