Specifications - Sony LBT-LV80 Operating Instructions Manual

Troubleshooting (continued)
The tape does not erase completely.
•The record/playback heads are
magnetized. Demagnetize them (see page
54).
There is excessive wow or flutter, or the
sound drops out.
•The capstans or pinch rollers are dirty.
Clean them (see page 54).
Noise increases or the high frequencies are
missing.
•The record/playback heads are
magnetized. Demagnetize them (see page
54).
Tuner
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display).
•Adjust the antenna.
•The signal strength is too weak. Connect
an external antenna.
A stereo FM program cannot be received in
stereo.
•Press STEREO/MONO so "STEREO"
appears in the display.
If other problems not described
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press c /CLOCK SET, ENTER, and
?/1 at the same time.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
56

Specifications

Amplifier section
The following measured at AC 120/220/240 V,
50/60 Hz
(LBT-LV80)
DIN power output (Rated)
Continuous RMS power output (Reference)
(LBT-LV60)
DIN power output (Rated)
Continuous RMS power output (Reference)
Inputs
PHONO IN (phono jacks):sensitivity 3 mV,
MIC 1/2 (phono jack):
VIDEO 1 IN (phono jacks):sensitivity 250 mV,
VIDEO 2 IN (phono jacks):sensitivity 250 mV,
MD IN (phono jacks):
Outputs
PHONES (stereo phone jack):
VIDEO OUT (phono jack):voltage 250 mV,
MD OUT (phono jacks):
FRONT SPEAKER :
(LBT-LV60)
(LBT-LV80)
Video section
Inputs
VIDEO1 IN (phono jacks): 1 V p-p, 75 ohms
VIDEO2 IN (phono jacks): 1 V p-p, 75 ohms
Outputs
VIDEO OUT (phono jack):1 V p-p, 75 ohms
S-VIDEO OUT (4-pin/mini-DIN jack):
240 + 240 watts
(4 ohms at 1 kHz, DIN)
300 + 300 watts
(4 ohms at 1 kHz, 10 %
THD)
150 + 150 watts
(6 ohms at 1 kHz, DIN)
200 + 200 watts
(6 ohms at 1 kHz, 10 %
THD)
impedance 47 kilohms
sensitivity 1 mV,
impedance 10 kilohms
impedance 47 kilohms
impedance 47 kilohms
sensitivity 450 mV,
impedance 47 kilohms
accepts headphones of
8 ohms or more
impedance 1 kilohm
voltage 250 mV,
impedance 1 kilohm
accepts impedance of 6 to
16 ohms
accepts impedance of 4 to
16 ohms
Y: 1 V p-p, unbalanced,
Sync negative,
C: 0.286 V p-p,
load impedance 75 ohms