GENERAL INFORMATION The PAS1200 is a multi-use air filtration device, equipped with pre-filters and a HEPA filter that are capable of filtering many airborne contaminants. An optional carbon pre-filter for capturing low concentrations of odors, vapors, gases, and volatile organic compounds, collectively known as OVG, is also available.
Page 4
Each HEPA filter (H610C-99) is tested & certified to capture at least 99.97% (9,997 out of 10,000) 0.3-micron particles. Note: The particulate filters in the PAS1200 do not remove odors, vapors or gases, including volatile organic compounds. Optional Vapor-Lock Carbon Filters (must be purchased separately) Vapor-Lock®...
2. Due to momentary start-up current surge, the unit requires a 15 amp circuit that is free of other loads. 3. Extension cords used for the PAS1200 must be UL listed, heavy duty No. 14/3 AWG industrial grade 3-wire type. Use of larger numerical gauge (lower capacity wire) power cord(s) may result in electrical shock, fire hazards and/or damage to unit.
Keep clear of the motorized impeller at all times to reduce the risk of injury. Warning: To reduce risk of fire or electrical shock, do not use the PAS1200 with any solid state speed control device. Do not use in a cooking area.
Page 7
The rear axle, 2 rear wheels, 2 bushings for securing the wheels to the axle and an Allen wrench are packed in a separate box that is included with the PAS1200. Place the axle through the circular opening in the lower rear section of the cabinet and center the axle.
15A circuit, including the unit plugged into the building electrical power supply receptacle, must not exceed 12 amps. A total of three PAS1200 units can be “Daisy Chained” on a 15 amp circuit, including the unit plugged into the building electrical power supply receptacle.
Note: The filters are not reusable, therefore, do not attempt to clean and reuse them. Caution: Abatement Technologies PAS1200 Portable Air Scrubber units are designed to meet or exceed standards for high efficiency air filtration equipment. Use only Abatement Technologies parts, including replacement filters.
6. Tighten the filter retaining bolts and reattach the HEPA filter access panel. Warning: Use only Abatement Technologies pre-filters, HEPA filters, and replacement parts. Substitute parts void the warranty, jeopardize worker and environmental safety, and adversely effect engineered performance levels.
Page 11
Note: Specifications subject to change without notice. AIRFLOW RATINGS (PAS1200 IS A VARIABLE SPEED UNIT) Note: Airflow ratings estimates are based on factory and independent testing @ 120 VAC with an air straightener and a traverse of readings taken with a computing vane-anemometer. Actual results may vary for various reasons, including motor and blower and HEPA filter tolerances.
Warning: To reduce the risk of fire, electrical shock or personal injury, always turn the unit “OFF” and disconnect power cord from supply receptacle before removing the control panel, replacing the HEPA filter and before cleaning or servicing the unit. The PAS1200 is equipped with an automatic restart motorized impeller that will restart without warning after a temporary power interruption or recovery from a thermal overload (over-heating) condition.
Recognized Testing Laboratory (NRTL). LIMITED WARRANTY Abatement Technologies, Inc (ATI) warrants that goods sold to the original user shall be free from defects in material and workmanship for a period of 1 year, except such as are commercially acceptable. This warranty does not include useful filter life. ATI does not warrant that the goods sold are merchantable or fit for any particular purpose.
Need help?
Do you have a question about the PAS1200 and is the answer not in the manual?
Questions and answers