Table of Contents
Advertisement
1.2.4. chair Back
The chair back features an adjustable shoulder support. By loosen-
ing the two hand screws, it is possible to tilt the shoulder support
forwards or backwards. To raise the chair back, loosen the two
bolts on the telescopic tube which is visible when the shoulder
support is folded back. The height of the chair back can now be
adjusted and increased by up to 10 cm.
Depending on how the powerchair is equipped, it may have: fixed
back tilt, manual back tilt or electric back tilt.
The fixed back tilt can be regulated (using tools) by adjusting the
tilt pole behind the chair back. The pole can be released from the
ball shaft at one end and either extended or shortened by turning
the ends in the middle piece. The manual back tilt can be adjusted
using the gas spring handle (push down) while pushing the chair
back into the desired position. Release the handle to secure the
chair back again.
The electric chair tilt can be operated from the tilt switch (normally
located on the same side as the control box).
1.2.5. neck sUpport
The height and position of the neck support (optional) are adjust-
able. By loosening both hand screws, the neck support can be
positioned as desired.
note! If you need to raise the neck support, it is possible to raise
the shoulder support, see above.
8
Advertisement
Table of Contents
