Anti-Tip Bracket Installation - GE Café series Installation Instructions Manual

INSTALLING THE REFRIGERATOR
Anti-Tip Floor Bracket Installation (Models PYE, CYE, and PWE only) (cont.)
LOCATING THE ANTI-TIP FLOOR
AT-2
BRACKET (cont.)
Figure 2 – Acceptable Screw
Placement Locations
Recommended Installation
– Wood
Minimum Acceptable #1 –
Wall Plate Stud
Minimum Acceptable #3 –

ANTI-TIP BRACKET INSTALLATION

AT-3
A
WOOD Wall and Floor Construction:
pilot holes in the center of each floor bracket
hole being used (a nail or awl may be used
if a drill is not available) AND remove the
locator template from the floor.
Mount the anti-tip floor bracket by fastening the
2, or recommended 4, #10-16 hex-head screws
tightly into place as illustrated in Figure 3.
Figure 3 – Attachment to Wall and Floor
Rear RH
Corner of the
Refrigerator
Installation Instructions
Recommended Installation
– Concrete
Minimum Acceptable #2 –
Wood Floor
Concrete Floor
Floor
2 Screws
Bracket
Must Enter
Wood or
Metal Stud
Floor
(cont.)
CONCRETE Wall and Floor Construction:
B
4 each 1/4" (6 mm) x 1-1/2" (38 mm) lag bolts
4 each 1/2" (12 mm) O.D. sleeve anchors
anchors into the concrete at the center of the
holes marked in Step 2.
holes. Place the anti-tip floor bracket as
indicated in Step 2. Remove the locator
template from the floor.
bracket and tighten appropriately.
WOOD Wall and TILE Floor Construction:
C
identified in Fig. 1. Drill an angled 1/8" (3 mm)
pilot hole (approx. as shown in Fig. 3) in the
center of each hole.
Minimum Acceptable Installation #1, as
illustrated in Fig. 2.
AT-4
Before pushing the refrigerator into the
opening, plug the power cord into the
A
receptacle and connect waterline (if equipped).
Check for leaks.
Locate the refrigerator's RH side and move back
approximately in line with the RH side of the
B
cabinet opening, W. This should position the
anti-tip floor bracket to engage the anti-tip base
bracket on the refrigerator.
Gently roll the refrigerator back into the cabinet
opening until it comes to a complete stop. Check to
C
see if the refrigerator front lines up with the cabinet
front face. If not, carefully rock the refrigerator
forward and backward until engagement occurs
and you notice that the refrigerator is fully pushed
up against the rear wall.
If Applicable: Adjust the rear (and front) wheel
height settings to fully engage the rear anti-tip
Wall
brackets, while also aligning the refrigerator
D
front with the cabinet front face.
Wall
NOTE:
Plate
Stud
If you pull the refrigerator out and away from the wall for
any reason, make sure the anti-tip floor bracket is engaged
when the refrigerator is pushed back against the rear wall.
Refer tp 239D1142 P001 Pub# 31-45484-2
30
POSITIONING THE REFRIGERATOR
TO ENGAGE THE ANTI-TIP FLOOR
AND BASE BRACKETS