Test Sequence - Whirlpool AWM8121 Service Manual

WHIRLPOOL CONSUMER SERVICES

TEST SEQUENCE

Step Advance to step Pump Out
by pressing : or Fill Via
(See Note 1) :
1 Start Pump out -
2 Advances Prewash Cold Fill No
automatically
3 Prewash button Main
wash
4 Eco button Main
wash
5 Auto (or press Main
rinse hold button) wash
(Note 2)
6 Easy ironing Fill via
button fabric
softener
7 Rinse hold button Pump out -
8 Advances Pump out -
automatically
(Note 3)
*Programme Sequence LED's: P = Prewash W = Wash R = Rinse RH = Rinse Hold D = Drain
Note 1 Unless indicated by "Advances automatically", the test cycle can only be advanced by
pressing the appropriate button once within five minutes, otherwise the machine will
pump out and a false fault will be indicated.
Note 2. This part of the test sequence can be terminated after the fill by pressing the "Rinse
hold" button but the NTC will not be checked for accuracy.
Note 3. This part of the test sequence can be terminated at any time by changing the cycle on
the cycle selector then reselecting drain and press the start button. Once the machine
is empty of water, the start button may be pressed and held until the start button light
goes off to reset the timer ready for the next wash.
If a failure is detected during the test sequence the timer will :
1. initiate the safety step routine :
A. Drain pump runs until pressure switch resets plus 30 seconds.
I. Main motor is turned off.
II. Water inlet valves are turned off.
III. Element is turned off
2. Stop the machine and illuminate the speed indicator LED's in a pattern to indicate the
fault code.
Temperature Time
-
60 s (fill)
heat
Warm Fill No 60 s (fill)
Heat
Warm Fill 60 s (fill)
Heat to 90°C 25 min
heat
Cold fill No 55 s (fill)
heat
Cold fill No 60 s
heat
6 min
Drum Component(s)
Rhythm Checked
Stationary Rinse hold and
Intensive rinse
buttons
Stationary Prewash button
and prewash fill
Stationary Eco button and
main wash fill
10 s on, Heating circuit,
6 s off NTC, leakage
80 s on, Easy ironing
2 s off button
80s on, Fabric softener fill
2s off
10s on, Pump
6s off
Spin Max Pump, spin
speed
Model AWM8121
Page 19 of 22
LED *
P W R RH D