Discharge Pump - SalonTech Spa Joy Manual

Discharge Pump

Discharge Pump Installation Instruction
1. Make a hole (size 1-3/8") for the on/off switch as shown Fig1. Pre drill required.
2. Place 1/8" clear hose into the rear of the switch and on/off switch into the hole.
3. The discharge pump kit is made to fit into the pedicure unit as shown in
Fig2.
4. Connect EZ
connector to the drain elbow.
5. Plug discharge pump outlet into black 2 minute timer.
6. Plug black 2 minute timer into the wall outlet.
7. It is very important that tip of white tube remain above the water level with one big loop as shown in Fig3.
Wall of Base
Fastener
On/Off Switch
Fig.1
Fig.1
1-1/4" Drain Elbow
1-1/4" EZ Connector
1" PVC Pipe
3/4" x 1 Adapter
Pre Assembled Discharge Pump ( Fig. 2)
1/2" Check Valve (Provided by MFG)
Operation Instruction
*Please DO NOT run dry
1. Turn to open the drain plug -wait 2 seconds.
2. Press on/off switch to activate the timer.
3. After the water has drained out from the basin. Press the
on/off switch again to stop.
Base
Fig. 3
White tube must
have the loop
Outlet
2 Min Timer
Clear Tube
Electrical Cord
Discharge
Pump
Discharge Pump Kit
P.12
*Loop to Connect Main
Drain (Must have the loop
before the main drain
to prevent AIRLOCK)