Kenmore ELITE 790. 7830" Use And Care Manual page 31

Warmer Drawer
Removing and replacing the warmer drawer
Electrical shock hazard can occur and
result in serious injury or death. Disconnect appliance
from electric power before cleaning and servicing the
warmer drawer.
To remove the warmer drawer:
1. Turn power OFF to the appliance before removing the
warmer drawer.
.
3.
4.
Open the warmer drawer completely.
On left warmer drawer rail, locate black release lever
and press up with finger while pulling out slightly on the
oven drawer handle. On right warmer drawer rail,
locate black release lever and press down with finger
while pulling out slightly on the warmer drawer handle
(See Fig. 1).
The warmer drawer should now be released from the
rails. Remove warmer oven drawer (using level & square
motion) completely out and away from the appliance.
To replace the warmer drawer:
1. Pull the bearing glides to the front of the outer
compartment glide channels until they snap into place
(See Fig. 3).
.
Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located
inside the empty warmer drawer compartment (See Fig.
2).
.
While holding the warmer drawer level and square
using the warmer drawer handle, push (do not farce) the
warmer drawer all the way into the outer compartment
glide channels all the way into the range. Open the
warmer drawer again to verify the glides have seated.
4.
If you do not hear the levers "click" or the bearing
glides do not feel seated remove the warmer drawer
and repeat steps 1 through 3 again. This will minimize
possible damage to the bearing glides.
Left-hand rail and release
\_
Warmer
drawer
handle
Right-hand rail and release
Fig. 1
I
Fig. 2
Fig. 3
31