Jeep Grand Cherokee User Manual page 61

11. Check Gages Warning Light
This light illuminates when the voltmeter,
oil pressure, or coolant temperature
gages indicate a reading either too high
or too low.
NOTE:
When the ignition switch is turned to OFF, the
fuel gage, voltmeter, oil pressure, and tempera-
ture gages will not show any readings. When
the engine is not running, turn the ignition
switch to ON to obtain accurate readings.
12. Part Time Indicator Light — If Equipped
This light indicates that the transfer
case shift lever has been moved to
the 4x4 PART TIME position. The light
may flash momentarily when you be-
gin to shift from 2WD (High Range) to 4x4 PART
TIME. The light will remain fully illuminated when
the shift is completed.
13. Transmission Over Temperature Warning
Light — If Equipped
This light indicates that there is excessive
transmission fluid temperature that might
occur with severe usage such as trailer
towing or snow plowing. If this light comes
on, stop the vehicle and run the engine at idle or
faster, with the transmission in N (Neutral) until the
light goes off.
This light will come on for 3 seconds as a bulb
check when the ignition is first turned ON.
14. Temperature Gage
Indicates engine coolant temperature.
The red zone to the far right signals
possible overheating. Seek authorized
service immediately if the gage operates
in the red zone. Refer to "Maintenance Proce-
dures" in Section 7 of this manual.
CAUTION!
Do not leave your vehicle unattended with the
engine running as you would not be able to react
to the temperature indicator if the engine over-
heats.
15. Reset Button
Pressing this button toggles between the odom-
eter and trip odometer display. Also, when the trip
odometer is displayed, press the "Reset" button
for 2 to 3 seconds to reset the trip odometer.
16. Odometer/Trip Odometer
The odometer shows the total distance the vehicle
has been driven. There are six digits including
leading zeros. The odometer is tamper-resistant.
The trip odometer records the distance the ve-
hicle has been driven since the "Reset" button
was pushed. To switch from the odometer being
displayed to the trip odometer being displayed,
press the "Reset" button.
17. O/D (Overdrive) Off Indicator Light — If
Equipped
The O/D OFF button is located on the gear
shift lever. This light will illuminate when the
O/D OFF button has been selected.
This light will come on for 3 seconds as a bulb
check when the ignition is first turned ON.
18. Seat Belt Indicator Light
A warning chime and an indicator light
will alert you to buckle the seat belts.
When the belt is buckled, the chime will
stop, but the light will stay on until it times
out (about 6 seconds).
After bulb proveout, the indicator light will illumi-
nate anytime the driver's seatbelt is unbuckled.
19. Anti-Lock Warning Light
The amber "Anti-Lock Warning Light" will
come on when the ignition is first turned
ON and stay on briefly as a bulb check. If
the bulb does not come on during start-
ing, have the bulb repaired promptly. This light
also illuminates to indicate that the Anti-Lock
Brake System self-check is in process at vehicle
start-up. If the light remains on after start-up, or
comes on and stays on at road speeds, it may
indicate that the ABS has detected a malfunction
59