Dialing A Stored Number; Inserting A Pause In The Dialing Sequence; Reviewing And Deleting Stored Numbers - Oregon Scientific OS6976 User Manual

To replace a number stored in a memory location with a redial number:
1. Repeat steps 1 through 2 in Storing a Redial Number
2. Press the mem button and REPLACE MEMO? shows in the display.
3. Press TONE*/exit to exit, or press the memory button again and the redial number replaces the
old number in that memory location. You will hear a confirmation tone.

DIALING A STORED NUMBER

1. Make sure the phone is ON by pressing the TALK/CALLBACK button.
2. Press mem button.
3. Press the number (0-9) for the desired memory location. The number dials automatically.
OR
1. Make sure the phone is OFF (not in TALK mode).
2. Press mem button.
3. Use the CID/VOL (-) arrow or CID/VOL (+) arrow button to scroll through the numbers stored in
memory until the desired number is shown.
4. Press TALK/CALLBACK. The numbers dial automatically.
IMPORTANT: If you make test calls to emergency numbers stored in memory, remain on
the line and briefly explain the reason for the call to the dispatcher. Also, it's a good idea to
make these calls in off-peak hours, such as early morning or late evening.

INSERTING A PAUSE IN THE DIALING SEQUENCE

When storing information in memory, press the # pause button twice within one second to insert a
delay in the dialing sequence of a stored telephone number when a pause is needed to wait for a
dial tone (for example after you dial 9 for an outside line, or to wait for a computer access tone).
Pause shows on the display as a "P . " Each pause counts as 1 digit in the dialing sequence.

REVIEWING AND DELETING STORED NUMBERS

1. Press mem, then use the CID/VOL (-) arrow or CID/VOL (+) arrow button to view the
entry.
2. While the entry is displayed, press channel/delete button to delete the entry. The
display shows DELETE?
3. Press channel/delete again to delete the entry. DELETED shows in the display.
os6976-en1.p65 35
32
5/20/2005, 12:09 PM