Gas burning with double wall air-cooled chimney (23 pages)
Summary of Contents for Adobelite EL PUEBLO 24
Page 1
EL PUEBLO FIREPLACE SIZES: 24 AND 30 INSTALLATION MANUAL Keep these instructions for future use. This fireplace is to be installed ONLY by a con- struction industry licensed contractor. Any permits and construction industry inpections required for installation should be obtained by this contractor.
Page 2
WARNINGS AND GENERAL SAFETY PRECAUTIONS IMPORTANT: THESE INSTRUCTIONS MUST BE LEFT WITH HOMEOWNER ALL WARNINGS OUTLINED IN THIS MANUAL MUST BE STRICTLY ADHERED TO BY THE INSTALLER AND HOMEOWNER. FAILURE TO FOLLOW these installation instructions will VOID THE WARRANTY and may cause a serious FIRE HAZARD. This fireplace is to be installed ONLY by a construction industry licensed contractor.
PRE-INSTALLATION REQUIREMENTS Fireplace installation must be in compliance with local building codes. Before installing the fireplace, consult the local construction industry to ensure that you are in compliance with all applicable codes, including permits and inspections. FIREPLACE LAYOUT AND FIREBOX PEDESTAL: The El Pueblo requires a 4”...
INSTALLATION FIREBOX ASSEMBLY: 1) BASE –Spread a thin layer of concrete mortar on the top of the firebox pedestal. Place the firebox base on the pedestal. Using the layout sketch, align the front of the base with the firebox base line and center the firebox along the center line.
FIREBOX ASSEMBLY (CONTINUED): 7) DOOR FRAME – The Door Frame al- lows an Adobelite Screen Door or Glass Door to be used with the fire- place. Begin by attaching the Door Frame to the Drain Tube. Position the Door Frame on top of the Drain Tube 5”...
FRAME ASSEMBLY: WARNING: Use care and wear gloves when handling the frame and diamond lath pieces. Cut edges of the diamond lath mesh are very sharp! ATTACH LATH TO DRAIN TUBE (FIG. 3) #6 x ” Before placing the El Pueblo frame around the firebox, Phillips Washer Lath needs to be attached to the and drain tube.