Table of Contents
Advertisement
Care & Cleaning
Surface elements
and drip bowls
Surface
elements
may appear
to have
cooled
after they have been turned off. The surface
elements
may still be hot and burns may occur if touched
before they have cooled
sufficiently.
Protective liners m Do not use aluminum
foil to line surface drip bowls, or reflector
pans. Only
use
aluminum
foil as recommended
in this manual.
Improper
installation
of these liners may result in risk of electric
shock, or fire.
Surface
elements
may be unplugged
and removed
to make
cleaning
the drip pans easier. The surface
elements
clean
themselves
when they are turned on. Food spilled on a hot
element
will burn off. Food spilled
on a COOL element
may be cleaned
with a damp
cloth --
any remaining
soil
will burn off the next time the element
is used.
To remove
the surface elements and drip bowls:
1. Lift the edge of the drip bowl across from the terminal
end. Lift the surface
element
and drip bowl together
just
enough to clear the cool<top.
2. While
holding
the drip bowl and surface
element,
gently
pull the terminal
end out from terminal
plug (See
Fig. 1).
Allow
element
support to rest on
drip pan inside rim.
Terminal
end
Cleaning drip bowls
Wash
in hot, soapy water
or in the dishwasher.
Rinse and
dry while still warm.
Hard to remove, burned
on soil can be
removed
by soaking
the drip bowls for about 20 minutes in
a lightly
diluted
liquid cleanser
or a solution
of ammonia
and water
(1/2 cup ammonia
to 1 gallon
of water).
A no-scratch
scrubbing
pad may be used after soaking.
DO NOT use abrasive
cleaners
or steel wool, they will
scratch the surface.
Always
rinse with clean water
and
polish dry with a soft cloth.
To replace drlp bowls
and surface
elements:
1. Slide the terminal
end on the surface
element
through
the opening
in the drip bowl (Refer to Fig. 1).
2. Align the surface element
support to rest on the rim
inside the drip bowl.
3. After the surface
element
is positioned
in the drip bowl,
line up the terminal
end with the terminal
plug as shown
(Fig. 1).
4. Hold the surface
element
and drip bowl together
as
level as possible and firmly
push the terminal
end into
the terminal
plug. Make sure element
terminal
is seated
properly
into terminal
plug. Make
sure the surface
element
is level to reduce
the hazard
of cookware
sliding off the element.
important
notes:
*
Be sure the range is cool before
removing
surface
elements
or drip bowls.
" Never
immerse a surface element
in water.
" Make sure drlp bowls
are in place - Absence
of these
bowls during
cooking
may subject
wiring or
components
underneath
to damage.
*
Be careful
not to bend terminal
ends when replacing
surface
elements
after cleaning.
Fig. 1
Terminal
plug
2O
Hide quick links:
Advertisement
Table of Contents
