Rs-232C Command Table; Screen Menu; Picture Menu - Sharp PN-Y325 Operation Manual

Controlling the Monitor with a PC (RS-232C)

RS-232C command table

How to read the command table
Command: Command field (See page 32.)
Direction: W When the "Parameter" is set in the parameter field (see page 32), the command functions as described
R The returned value indicated under "Reply" can be obtained by setting "????", "
Parameter: Parameter field (See page 32.)
Reply: Response (Returned value)
* : "○" indicates a command which can be used in power standby mode.
"–" indicates a command which cannot be used in power standby mode.
(When STANDBY MODE is STANDARD. When set to LOW POWER, RS-232C commands cannot be used.)
Power control/Input mode selection
Function
POWER CONTROL
INPUT MODE SELECTION
* If power standby mode is entered when the input mode is USB, the input terminal that was used prior to switching to USB will
respond, not USB.

SCREEN menu

Function
SIZE (DVI-D, HDMI[PC], D-SUB[RGB])
SIZE (HDMI[AV], D-SUB[COMPONENT],
D-SUB[VIDEO], USB)
AUTO

PICTURE menu

Function
BRIGHT
COLOR COLOR MODE
ADJUSTMENT
36
E
under "Control/Response Contents".
(repeater control) in the parameter field (see page 32).
Command Direction Parameter
POWR W
R
INPS W
R
Command Direction
WIDE WR
WIDE WR
ASNC W
Command Direction
VLMP WR
BMOD WR
Reply
0 Switches to standby mode.
1 Returns from standby mode.
0 Standby mode
1 Normal mode
2 Input signal waiting mode
0 Toggle change for input mode.
1 DVI-D
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
4 D-SUB[VIDEO]
9 HDMI[AV]
10 HDMI[PC]
11 USB
1 DVI-D
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
4 D-SUB[VIDEO]
9 HDMI[AV]
10 HDMI[PC]
11 USB*
Parameter Reply
1-3 1-3 1: WIDE, 2: NORMAL, 3: Dot by Dot
1, 4, 5 1, 4, 5 1: WIDE, 4: NORMAL, 5: Dot by Dot
1 When the input mode is D-SUB.
Parameter Reply
0-31 0-31
0 0 STD
2 2 VIVID
3 3 sRGB (When the input mode is DVI-D, D-SUB[RGB], HDMI[PC])
4 4 HIGH ILLUMINANCE
5 5 USB
?" or "???+"
Control/Response contents
Control/Response contents
Control/Response contents
*
○
*
-
*
○