Sharp Aquos LC-46LB700X Operation Manual page 69

Blu-ray disc Setup
Communication Setup (continued)
For the advanced setting (the setting of the
12
Ethernet connection speeds), press c / d to
select "Yes" or "No", then press ENTER.
• Normally select "No", then press ENTER. (Go to
the step 14.)
Perform advanced setup?
Yes
• The Ethernet connection speeds can be set when
you select "Yes", then press ENTER.
For the Option Ethernet connection speeds,
13
press c / d to select the connection speed,
then press ENTER.
ETHERNET Connection Speeds
Auto-Detection
10M Half Duplex
100M Half Duplex
• As automatic detection is made (factory preset
mode), this setting is not normally necessary. If a
situation occurs in which the Ethernet connection
fails, etc., change the setting and confi rm if the
Ethernet connection successfully works.
When the connection speed is set, select "Next",
then press ENTER.
For testing the connection to the internet, after
14
confi rming the settings, press c / d to select
"Test", then press ENTER.
• "Test" is available only when setting to obtain
the IP address automatically. "Test" cannot be
selected if the IP address has not been obtained
automatically.
Confirm the current setting.
IP Address
Netmask
Gateway
DNS Address
MAC Address
• As a result of the test, if the internet connection
fails, enter the setup values manually.
Press c / d to select "Complete", then press
15
ENTER.
No
Option
10M Full Duplex
100M Full Duplex
Next
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xx:xx:xx:xx:xx:xx
Complete
67