Table of Contents
Advertisement
General Care & Cleaning
Changing
the Oven Light (some models)
For models equipped with the interior oven light, the light bulb is located at the
Oven
rear of the oven and is covered with a glass shield held by a wire holder. The glass
Light
shield must be in place whenever the oven is in use.
Wire
Holder
To replace
the oven light bulb:
1.
Turn electrical power off at the main source or unplug the range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug the range back in).
6.
The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
Be sure the range isunplugged and all parts are COOL before replacing
oven light. Wear a leather-faced glove for protection against possible broken glass.
Care and Cleaning
of Stainless
Steel
(some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required
for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning
table for detailed cleaning instructions.
......
i
Adjusting the Oven Temperature
Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe
times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times,
you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
t.
Press
B_koo
2.
Set the temperature to 550°F (287°C) by pressing and holding the A.
3.
Within 2 seconds, press and hold Bake until the 2 digit display appears. Release B_ko. The display now indicates the amount
of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control
has the original factory calibration, the display will read "0."
4.
Thetemperaturecann_wbeadjustedup_rd_wn35°F(17°C)_in5°Fstepsbypressingandh_ldingthe
A
or V.
Adjust
until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear
before the number to indicate that the oven will be cooler by the displayed amount of degrees.
5.
When you have made the desired adjustment, press _
to go back to the time of day display.
Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.
19
Hide quick links:
Advertisement
Table of Contents
