General Safety Information - Pentair DAH1001A User Manual

INTRODUCTION
1. Before installing the electric heater, read these instructions carefully. Failure to follow
these instructions could damage the product or cause a hazardous condition.
2. Check the ratings on the heater label to assure the product is suitable for your
application.

GENERAL SAFETY INFORMATION

1. Protect the lead wires from coming in contact with sharp objects, hot surfaces, and/or
chemicals.
2. If continuous operation of the heater is essential to the safe functioning of any other
equipment, adequate warning devices must be installed to assure safe operation at all
times.
Do not use these electric heaters in dusty, dirty, corrosive, or hazardous locations.
Reduce the thermostat from factory setting to a recommended setting not to
exceed 75 F for most applications.
Portions of the heater can get hot. Adequate protection must be taken to protect
people from potential burns and to protect other components from this heat.
Always allow the heater to cool before touching it.
Thermal sensitive devices or materials may need to be located further from the
heater than the minimum recommended distance.
Heaters must not be installed on wood or other combustible surfaces.
This heater must only be installed in a totally enclosed enclosure.
- 2 - © 2012 Pentair Technical Products
English
WARNING
To avoid electric shock and equipment damage, disconnect
any power supplies to the enclosure before installing the
electric heater. Do not energize any circuits before all
internal and external electrical and mechanical clearances
are checked to assure that all assembled equipment
functions safely and properly.
CAUTION
PH 763 422 2211 • hoffmanonline.com 87565511