Maintenance; Replacement Parts - West Marine 200SS Owner's Manual

MAINTENANCE

ABOUT STAINLESS STEEL
Stainless steel exposed to prolonged periods of high heat will change color and texture. Magma grills require no
preheating. Not preheating will keep your grill cooler and greatly extend its life and beauty. Texture and color
change is normal on components and will not affect the product's performance. Stainless steel scratches easily
and should never be cleaned with abrasive pads, brushes or abrasive cleaners.
COMPLETE DISASSEMBLY FOR CLEANING (or access to Piezo Igniter)
1 - Remove entire grill body from L-Bracket of Mount.
2 - Unthread and remove burner, fire pan and grease pan from outer bowl.
3 - To inspect piezo igniter, remove single screw from inside of outer bowl to release igniter box and carefully
inspect for corrosion or loose wire connection.
4 - To reassemble, reverse above steps and steps 6 through 9 from page 3 Setting Up Your Grill.
CLEANING WITH OVEN CLEANER
We recommend disassembly and complete cleaning at least once a year, depending on amount of use, and always
prior to long-term storage. For burnt-on residue we recommend "Easy-Off" brand "Original Formula Oven & Grill
Cleaner". Just spray it on, let it set, wash in warm soapy water and rinse. If cleaner is used, complete disassembly
is required to remove any cleaner residue left between components. Wash all components with soapy water after
using cleaner. CAUTION: AVOID CONTACT OF OVEN CLEANER WITH CONTROL VALVE, PLASTIC IGNITER,
ELECTRODE WIRE AND ALL BOAT SURFACES AND FOLLOW MANUFACTURER'S DIRECTIONS ON OVEN CLEANER.
EXTERIOR STAINLESS STEEL COMPONENTS
Cleaning the exterior surface after every use will help prevent discoloration. Use soapy water with a soft cloth or
sponge. Rinse with fresh water and dry. We recommend covering the grill between uses. Optional covers are
available through www.MagmaProducts.com. CAUTION: ABRASIVE PADS OR CLEANERS WILL DAMAGE THE FINISH.
INTERIOR COMPONENTS & GRILL GRATES
Remove heavy residue from barbeque and empty grease tray between each use. Grates can be cleaned with brass
wire brush while grill is warm.
CERAMIC ELECTRODE
Located just beside the burner, it should be kept clean of grease and debris. Electrode spark cap must be directly
over the electrode for proper operation, Be careful not to damage the ceramic insulation or the wire.
CONTROL VALVE
(562) 627-0500
All valves are set and tested at the factory. Do not attempt to adjust or disassemble the valve. Call
if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice.

REPLACEMENT PARTS

All replacement parts are readily available through West Marine and Boat US stores, catalog or website:
www.westmarine.com
7