Cisco SPA8000 Quick Installation page 4

E.
Connect one end of an Ethernet
network cable (included) to the
ETHERNET port of the Gateway.
Connect the other end to your
LAN/cable/DSL modem.
F.
Connect the included power
adapter to the Gateway's power
port, and then plug the power
adapter into an electrical outlet.
Press the On switch to power on the
Gateway. The power LEDs on the
front panel will light up as soon as
the Gateway powers on.
2�
n
Co
If the Gateway is pre-
nfi
configured by your ITSP,
then you do not need to
change any of the default
gu
voice settings. Refer to the
documentation supplied by
rat
your service provider for
more information.
io
Ethernet Connection
AUX Connection
Power Plug
5