Advertisement
3.2 Alarm messages
Alarm messages may be displayed on the
terminal indicating which area the alarm
has occurred
in. Before proceeding, the
alarm
messages
acknowledged. Press the OK key after
each alarm message to acknowledge the
messages. Alarm messages are very rare.
3.3 Turning areas off
After entering the PIN code and
displaying possible alarm messages the
terminal will indicate whether the area is
armed or not. If the area is armed the
terminal will display: „Is On. Push Off".
Please pay attention here: the area might
not be armed. In that case „Is Off. Push
On" (see 3.4) will be displayed. Use the
arrow key
areas. If you are convinced that all the areas are disarmed push the END key to
complete.
3.3.1 Selecting single or all areas
If you wish to disarm all the areas you
are allowed to control, use the right
arrow key
after that push the END key to log out from the system.
If you wish to turn the areas off selectively
use the down arrow
between the areas and push OFF when
desired room number or area name is
displayed. If all desired areas have been
disarmed push END to complete.
have
to
to scroll through all the
, then push OFF and
key to scroll
be
Advertisement
