Fujitsu Lifebook i-4190 User Manual page 71

Problem
You have installed a
parallel port device, a
serial port device or a
USB device. Your
LifeBook does not
recognize the device, or
the device does not seem
to work properly.
PC Card Problems
A card inserted in the PC
Card slot does not work or
is locking up the system.
Power Failures
You turn on your LifeBook
and nothing seems to
happen.
Possible Cause
You may have the wrong
I/O address selected for
your device.
Your device and another
device are assigned the
same I/O address.
Parallel port is set to
output only.
The card is not properly
installed.
The card may have been
installed while an
application was running,
so your LifeBook is not
aware of its installation.
Your software may not
have the correct software
driver active.
You may have the wrong
I/O address selected for
your PC Card device.
Your PC Card device and
another device are
assigned the same I/O
address.
The installed battery is
completely discharged, or
there is no Power adapter
installed.
The battery is installed but
is faulty.
The battery is low.
The power adapter is not
plugged in properly.
Possible Solution
See your device documentation and
software documentation to determine
the required I/O address. Change the
settings in the BIOS setup utility.
Check all I/O addresses located within
the BIOS setup utility and any other
installed hardware or software to make
sure there are no duplications.
Check parallel port setting in the BIOS
and set to bi-directional or ECP.
Remove and reinstall the card.
Close the application and restart your
LifeBook.
See your software documentation and
activate the correct driver.
See your PC Card documentation to
determine the required I/O address.
Change the settings in the BIOS.
Check all I/O addresses located within
the BIOS setup utility and any other
installed hardware or software to make
sure there are no duplications.
Check the Status Indicator Panel to
determine the presence and condition of
the batteries. Install a charged battery or
a Power adapter.
Use the Status Indicator panel to verify
the presence and condition of the
batteries. If a battery is indicating a
short, remove that battery and operate
from another power source or replace
that battery.
Check the Status Indicator Panel to
determine the presence and condition of
the battery. Use a Power adapter to
operate until a battery is charged or
install a charged battery.
Verify that your adapter is connected
correctly.
61