Back & Forwards, Up & Down; Trim (Rotation) - Swann Micro Lightning remote control model helicopter Operating Instructions Manual

Remote control model helicopter
Table of Contents

Advertisement

Back & Forwards, Up & Down: This helicopter features counter-rotating coaxial rotors (a fancy way
of saying two rotors which spin in opposite directions). If you're any kind of expert on helicopters,
you'll know that this is not the same way that full-scale helicopters are usually made – they've got a
uni-directional main rotors with a vertical tail rotor. We think that this coaxial design works best for
these scale models because:
It's more stable than a single rotor. Because the rotors move in opposite directions, the helicopter
has less of a tendency to spin the other way.
It is way easier to set up. There are only two trim settings to get right, as opposed to the three trim
settings that are required for the more conventional helicopter design.
More rotors mean more lift, which means an easier to fly and more manoeuvrable helicopter.
However, because the tail rotor is horizontal rather than vertical, the helicopter has a tendency to
ascend whilst moving forwards, and descend whilst reversing. This isn't really a problem if you ease off
on the throttle whilst moving forward and increase the throttle whilst moving backwards. You'll get a
feel for it pretty quick.
Trim (Rotation): If you find that the helicopter is turning slowly left or right when you're not using the
right stick on the controller, then you'll need to adjust the trim. The trim knob is located in the centre
of the controller, between and just below the primary sticks.
You'll probably have to do this every couple of flights, but it only takes a moment. Basically, the trim
'fine-tunes' the speed of the rotor blades, and will help keep the helicopter flying straight.
If the helicopter is rotating clockwise (it's turning right from the imaginary miniature pilot's perspective)
then rotate the trim knob counter-clockwise.
If the helicopter is rotating counter-clockwise (it's turning left from the imaginary miniature pilot's
perspective) then rotate the trim knob clockwise.
!
WARNING:
near eyes or face.
Do NOT fly
5

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Micro Lightning remote control model helicopter and is the answer not in the manual?

Questions and answers

David J Lind
March 19, 2025

The battery in the plane will not charge.

1 comments:
Mr. Anderson
March 19, 2025

The battery in the Swann Micro Lightning remote control model helicopter may not charge for the following reasons:

1. Incorrect USB Port – The helicopter must be connected to a USB port supplying exactly 5V @ 500mA.
2. Improper Connection – The USB plug should be connected first before attaching the helicopter. The red LED in the USB plug should light up before connecting the helicopter.
3. Helicopter Not Turned Off – The helicopter must be turned off before charging.
4. Faulty Connection – If the LED in the USB plug does not go out after connecting the helicopter, check the connection integrity.
5. Damaged Cable or Port – A faulty charging cable or USB port may prevent charging.

Checking these factors can help resolve the charging issue.

This answer is automatically generated

gabriel
April 26, 2025

lower rotor b where to buy them

This manual is also suitable for:

Micro lightning

Table of Contents