Table of Contents
Advertisement
38 Service Search
Searching every service of SMATV system
4.2 Copying services
To search every service of a SMATV system, if the digital re-
ceiver is connected to it, perform the following steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to SMATV.
3. Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4. Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5. Set the Polarization option to the polarization of your
desired transponder.
You can search pay services as well as free services as follows:
• To search only free services, set the FTA/Scrambled option
to FTA only.
• To search only pay services, set it to CAS only.
• To search both free services and pay services, set it to FTA
+ CAS.
To start service search, select the Start Search item; then a list
box appears, in which found services will be listed. When it has
completed, press the
at any time or to exit without saving, press the
The digital receiver maintains a separate services list with each
tuner. If a certain service is registered on only one tuner, it
may be impossible to watch one service while recording. You
can copy entries of one tuner's services list to the other tuner's
services list to avoid such inconvenience.
button to save found services. To stop
OK
button.
EXIT
Advertisement
Table of Contents
