Page 1
Model H-223 401.8 MHz GOES Satellite Antenna Owner’s Manual Revision: 1.00 NOTICE This product embodies technology that is confidential and proprietary technology of DESIGN ANALYSIS ASSOCIATES, INC., and which is protected by United States copyright laws and international copyright treaty provisions, and/or by contract and applicable laws of trade secrecy.
Page 3
USER agrees to return the PRODUCT to DESIGN ANALYSIS if and when the PRODUCT is deemed to be no longer of use. In return therefore, USER will receive from DESIGN ANALYSIS a redemption fee of $10.00. H-223 ® User Agreement/W...
Page 4
EXCEPT FOR THE EXPRESS WARRANTIES ABOVE, DESIGN ANALYSIS SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, INCLUDING, WITHOUT LIMITATION, ALL IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. (iv) UNDER NO CIRCUMSTANCES WILL DESIGN ANALYSIS BE LIABLE FOR H-223 ® W-2 User Agreement/W Warranty ATER...
Use, duplication, or disclosure by the United States Government is subject to restrictions set forth in paragraph (c) (1) (ii) of the rights in Technical Data and Computer Software clause at 52.227-7013. The Contractor-manufacturer is DESIGN ANALYSIS ASSOCIATES, INC., 75 West 100 South, Logan, Utah 84321. H-223 ® User Agreement/W Warranty W-3...
2.0 Assembly ® The W H-223 antenna is shipped disassembled in a 4" x 4" x 48" box. You will need a 6-inch ATER adjustable wrench and a pair of pliers to assemble the antenna. Unpack and familiarize yourself with the parts.
Step 3: With an adjustable wrench, continue to rotate the cam element past the 30 degree point until the wrench flats are parallel with the boom. At this point the two elements will be firmly locked into place. H-223 1-2 Assembly & Installation...
Page 8
Screw the threaded studs into the boom and tighten lightly with a pair of pliers. Do not over tighten. Over tightening may strip out the threads in the plastic insulator inside the boom. Step 4 Install the four Dipole Elements H-223 Assembly & Installation Instructions 1-3...
For a lead wire longer than 20 feet use LMR-400 or similar low loss cable. Install a lightning arrester or other protective device in the gauge station. Use a drip-loop or roof jack to prevent water from following the coax into the gauge station. H-223 1-4 Assembly & Installation...