Advertisement
Before Setting Warmer
Upright Position
Downward Position
Figure 1
Figure 2
Drawer Control
Arranging
Warmer
Drawer Rack Positions
Set the warmer drawer rack in the vertical position as shown below.
The rack can be used in 2 ways:
• In the upright
position
to allow low profile food items to be placed both under
and on top of the rack (for example, rolls or biscuits on top of the rack and a
casserole dish under).
,, In the downward
position for placement of light weight food items and empty
dishware (for example, rolls or pastries and dinner plates).
Setting Warmer
Drawer Control
To Operate
the Warmer
Drawer
The purpose of the warmer drawer is to keep hot cooked foods at serving tem-
perature. Always start with hot food. It is not recommended
to heat cold food in
the warmer drawer.
All food placed in the warmer drawer should be covered with a lid or aluminum foil ":"
to maintain moisture and softness. Do not cover crisp foods. Do not use plastic
wrap to cover food. Plastic may melt onto the drawer and be very difficult to _,'i," :
clean,
i: . ...........
,i
Use only dishware, utensils and cookware recommended
for oven use in the
warmer drawer.
Always use potholders or oven mitts when removing food from the warmer drawer
as cookware and plates will be hot.
Indicator
Light
The indicator light is located below the thermostat control knob. It turns on when
the control is set, and stays on until the control is turned off. Make sure indicator
light is off when removing food from drawer.
Warmer Drawer
Humidity
Controller
Feature
This feature may be used to control humidity in the Warmer Drawer.The control knob
is located on the inner front panel of the Warmer Drawer.
For dry heat: Slide the humidity control knob in the direction of less moist (.©)
v
(Figure 1).This allows more of the moist heat to escape and provides a dryer environ-
ment for the food in the Warmer Drawer.
For moist heat: Slide the humidity control knob in the direction of more moist (:0_.)
(Figure 2). This will help keep the food in the Warmer Drawer from drying out. Both
heat and moisture will be applied to the Warmer Drawer cavity.
Advertisement
