For Bi-Amp - McIntosh MC152 Owner's Manual

8. Referring to figure H, connect the
Loudspeaker hookup cables with
banana plugs into the hole at the top
of the MC152 Negative and Positive
Output Terminals. The terminals are
indentified as 2Ω (ohms),
4Ω (ohms) or 8Ω (ohms)
connection to match the
impedance of the Loud-
speaker, being careful
to observe the correct
polarities.
Note: The illustration on separate sheet "Mc1B" is
connections for 8Ω (ohms) Loudspeakers.
If the Loudspeaker's impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to "General Information" Note
3 on page 3 for additional information.
WARNING: Loudspeaker terminals are hazardous
live and present a risk of electric shock.
For additional instruction on making
Loudspeaker Connections contact your
McIntosh Dealer or McIntosh Techni-
cal Support.
9. Connect the MC152 power cord to an active AC
outlet.
Spade Lug or Wire Connections:
10. Connect the Loudspeaker hookup cables to the
MC152 Negative Output Terminal and Positive
Output Terminal indentified as 2Ω (ohms), 4Ω
(ohms) or 8Ω (ohms) connection to match the
impedance of the Loudspeaker, being careful to
observe the correct polarities. Insert the spade
lug connector or prepared section of the cable end
into the terminal side access hole, and tighten the
terminal cap until the cable is firmly clamped into
the terminals so the lugs or wire cannot slip out.
Refer to figures 7 and 8.
Figure G
Note: The illustration on separate sheet "Mc1B" is
Figure H
connections for 8Ω (ohms) Loudspeakers.
If the Loudspeaker's impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to "General Information" Note
3 on page 3 for additional information.
WARNING: Loudspeaker terminals are hazard-
11. Connect the MC152 power cord to an active AC
outlet.
Figure 7 Figure 8
ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections con-
tact your McIntosh Dealer or McIn-
tosh Technical Support.
How to Connect for Bi-Amp
11