Control Panel - Whirlpool ADP9000 Instruction Manual

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance
Fill the detergent dispenser
Check the rinse aid level
Load the baskets
Select a program
How to use All-in-1 function
How to use Alt function
How to use Delay start function
Running the dishwasher
Changing the programme
Add forgotten dishes in the
dishwasher
If the appliance is switched
off during a wash cycle
Switch off the appliance
Turn off the water tap,
unload the baskets
Press the Power key-press to switch on the appliance. Open the door.
Compartment
With each wash cycle.
Compartment
With pre-wash only.
"
(Refer to the Fill the Detergent and Rinse Aid dispensers section.)
Electric indicator on control panel.
Or via the Mechanical indicator
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door, press the Program key-press and the selected program light will light up.
"
( See the section entitled Operationg instruction
Press the All-in-1 key-press to select the function. (Only programs of auto, intensive,
heavy or normal can select the function.)
Press the Alt key-press to select the function. (Only programs of auto, intensive, heavy, normal or glass
can select the function. When select the function, the lower spray arm runs or the upper arm
runs only , or lower spray arm and upper arm run alternately . These will be displayed in the
display Window .)
Note: While the dishwasher is running, If the upper and lower spray arm indicators are both
light, that means the two arms are a
means the two arms are running simultaneity;
Press the Delay key-press to delay the start of washing, one press add half an hour, and you can
delay the start of washing up to 9.5 hours.
T urn on the water tap and press the Start/Pause key-press. The machine will start working
after about 10 seconds.
Note:If you want to power off the dishwasher while it is running, you must press the
Start/Pause key-press to pause the dishwasher first, then press the power key-press
more than 3 seconds to turn off the power.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause key-press to pause, the press the program key-press for more than 3 seconds to
cancel the running program.
3. Select a new program.
4. Restart the dishwasher.
1. Press START/PAUSE key-press.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, Press START/PAUSE key-press,
start running again after 10 seconds.
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
from the first step.
Note: If you want to power off the dishwasher while it is running, you must press Start/pause
key-press to pause first, then press the power key-press to turn off the power
When the working cycle has finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power key-press.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better. Unload the appliance, starting from the lower basket.
"
"
.)
lternate washing, but if they are both off, that
the dishwasher will
Ope n the door ca refully.
Hot steam may e scape
whe n the d oor is opene d!