Basic Steps - Panasonic SA-HE7 Operating Instructions Manual

1 2,5
3 4
1
POWER
2
DSP SOUND MODE SFC MODE
3
DSP SOUND MODE
4
SIZE, DISTANCE, D-INPUT
SFC MODE
FILTER, DR COMP, DIMMER
INPUT SELECTOR
5
DSP SOUND MODE SFC MODE
4
INPUT SELECTOR
Customizing your receiver

Basic steps

If you allow about 10 seconds to elapse between settings, the
procedure is canceled, all settings are returned to how they were,
and the previous display is restored. Begin again if this occurs.
1
Press [POWER, 8].
2
Press [DSP SOUND MODE] and
[SFC MODE] at the same time.
3
Press [DSP SOUND MODE] to select
the item you want to change.
Each time you press the button:
SIZE/DISTANCE/FILTER/DR COMP/D-INPUT/DIMMER
↑
4
Change the settings (a a below).
Repeat steps 3 and 4 to complete the necessary
settings.
5
Press [DSP SOUND MODE] and
[SFC MODE] at the same time.
Changing the settings
SIZE
1 1 Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT / CENTER / SURROUND / SUB-WFR (Subwoofer)
↑
2 2 Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
FRONT: SMALL , / LARGE
CENTER and SURROUND: NONE , / SMALL , / LARGE
SUB-WFR: NO , / YES
3 3 Repeat 1 1 and 2 2 to change other SIZE settings.
DISTANCE
1 1 Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT / CENTER / SURROUND
↑
2 2 Turn [INPUT SELECTOR] to set the distance.
3 3 Repeat 1 1 and 2 2 to change other DISTANCE settings.
FILTER
Turn [INPUT SELECTOR] to set the cut-off.
When you turn the selector:
100 , / 150 , / 200
DR COMP
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF , / STANDARD , / MAX
D-INPUT
1 1 Press [SFC MODE] to select the input position you want to set.
Each time you press the button:
CD COAX / DVD OPT2 / TV OPT1
↑
These are the factory settings. Actual displays depend on the
changes you make. If you change one setting, the other
corresponding setting will also change.
2 2 Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
COAX , / OPT1 , / OPT2
↑ ↑
3 3 Repeat 1 1 and 2 2 to change other D-INPUT settings.
DIMMER
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF , / ON
13
RQT5908