Preparing And Assembling The Unit; Instructions For Use - Freshtech SmartPRESERVE FTAC-13-10 User Manual

InStruCtIonS for uSe

partS needed
Ensure all parts listed below are handy. Refer to pages 6 and 7 for parts diagram.
• Appliance, Detachable Power Cord
• Inner Pot
• Jar Rack
• Drip Cup
• Gasket, Vent Filter (these parts should be securely assembled inside
the lid prior to operating the appliance)
• Vent Cleaner
aSSemBLIng aLL partS
1. SLIDE and lock Drip Cup into the black tab located
on the back of the Appliance. (figure A)
2. PLACE Rack in the Inner Pot with the wire base facing
down as it contacts the pot (as shown in the parts
diagram on pages 6 and 7) then place Inner Pot inside
the Appliance base.
3. PLUG in power cord into the Appliance and then into
the wall outlet. Once powered up, you will hear a
welcome tone and the display will read WELCOME.
4. DO NOT use Appliance without the vent filter in place.
openIng and CLoSIng Your freSHteCH appLIanCe LId
to open the appliance Lid
1. Always use the top handle for unlocking and opening the Appliance Lid.
2. To open and unlock the Lid, rotate the top handle counterclockwise until the Lid
handle arrow meets the unlock symbol. Lift the Lid handle up.
3. The Lid will rest in place at an angle slightly past vertical.
4. Always take care while opening the Lid, making sure to open slowly and away from you.
to Close the appliance Lid
1. Always use the top handle for closing and locking the Appliance Lid.
2. To close, slowly lower the Lid down, using the top handle, until the Lid meets the
Appliance Base.
3. Rotate the top handle clockwise until the Lid handle arrow meets the lock symbol.
4. Always take care while closing the Lid, making sure not to close too quickly.
IMPORTANT - Do not attempt to unlock the Lid while the Appliance is in operation
(i.e. Pre-Heating, Sensing or Preserving) as indicated by the illuminated red or
orange lights on the display panel.
12
figure A