Removing The Ram Module - Wyse X90 Installation Manual

6
7. To remove the existing RAM module, use your fingers to unlock the two locking clamps
Figure 9 Removing the RAM module
8. Insert the new RAM module into the connector of the original module, and then press
9. Replace the access cover in the reverse order as shown in Figures 5 and 6.
10.Reconnect the power cord and power adapter.
11. Proceed to "Verifying the Mobile Thin Client's Operation."
at either side of the module by pushing the clamps in the direction of the arrows shown,
see Figure 9. The module should pop up from its socket. Lift out the RAM module.
down on the module so that the two locks will snap in place, securing the module.