Wireless Client Mode - ZyXEL Communications nwa1100-n User Manual

5.4.4 Wireless Client Mode

Use this screen to turn your NWA into a wireless client. Select Wireless Client as the Operation
Mode. The following screen displays.
Figure 22 Wireless > Wireless Settings: Wireless Client
The following table describes the general wireless LAN labels in this screen.
Table 6 Wireless > Wireless Settings: Wireless Client
LABEL
Basic Settings
Disable Wireless
LAN Interface
Operation Mode
Site Survey
SSID Profile
Channel
Advanced Settings
MAC Clone
Output Power
NWA1100-N User's Guide
DESCRIPTION
Select this option to turn off the wireless LAN.
Select Wireless Client in this field.
Click this to view a list of available wireless access points within the range. Select the AP
you want to use and click Selected.
Note: After selecting Wireless Client as the Operation Mode in the Basic Settings
section, you must click Apply to be able to select from the AP list.
Select an SSID Profile from the drop-down list box. The SSID profile defines the SSID and
security settings you want to use to set up a wireless network or connect to a wireless
device.
This shows the operating frequency/channel in use. This field is read-only when you select
Wireless Client as your operation mode.
Choose Manual to configure the NWA's MAC address by cloning the MAC address from a
computer on your LAN. Choose Auto to use the factory default MAC address of your NWA.
Set the output power of the NWA in this field. If there is a high density of APs in an area,
decrease the output power of the NWA to reduce interference with other APs. Select one
of the following Full (Full Power), 50%, 25%, 12.5% or Min (Minimum). See the
product specifications for more information on your NWA's output power.
Chapter 5 Wireless Settings Screen
59