Table of Contents
Advertisement
User Manual
Setup Active Zones
Use this menu item to setup the active zones for motion detection. When this menu item is selected, the menu will be
removed from the screen and video from the currently selected camera will be displayed. A 16 x 16 grid is superimposed
over the current video image, allowing for precise configuration of active zones. Currently disabled zones are tinted and
currently enabled zones clear.
Ensure that the required camera is selected by pressing the Number button and then press the Function button to access
a help screen that will overlay the current video image.
5
The Stop and Pause buttons are used to determine the action of the cursor, and it’s current status can be seen by the way
in which it is displayed. It has three possible modes NEUTRAL (blank square), ENABLE (square with a tick inside) and
DISABLE (square with a cross inside). No Action will have no effect on the current cursor position; Enable will change the
current cursor position to an active zone; Disable will change the current cursor position to a non-active zone.
By default, all zones are initially enabled. To disable a zone or series of zones, first use the Jog (up/down) and Shuttle (left/
right) to navigate to the zone. Next, press the Stop button. Then use the Jog/Shuttle to move the cursor over the zones
that are to be disabled. As the cursor leaves the zone, the zone will be tinted to indicate that the zone is now disabled.
Using the cursor in this way, areas of the scene can be ‘painted’ with the cursor to become disabled zones. Enable disabled
zones in the same way, using the Pause button.
Use the sensitivity scope to adjust the motion detection sensitivity for the scene. The sensitivity scope is the bar located
near the left-hand corner of the screen. The black bar raises and lowers to indicate the degree of motion detected. When
the black bar reaches the red bar, a motion detection alarm is activated.
Raise and lower the sensitivity level using the Play Forward and Play Reverse buttons. The red bar will move up and
down accordingly and the sensitivity level is also displayed as a numeric value.
To end configuration and save changes, press the Enter button. To cancel changes, press the Menu button.
Indicate Detection
Detection
ON
Camera Titles
Camera AGC
Camera Disable
Covert Camera
Camera Scope
MonB SVHS
Public Display Monitors
Titles Display
Edit Titles
Enabled Zones
Cursor
Disabled Zones
Sensitivity Scope
Indicate Detection
This menu item is used to specify whether motion detection is indicated on-screen by displaying
the letter M.
Use the Jog to turn this feature on or off. To confirm the selection and exit the menu, press the
Enter button. To exit the menu without making changes, press the Menu button.
When the Camera Setup menu item is selected from the Main menu, a sub-menu is displayed.
From this sub-menu, a user can:
• Edit the title for each camera.
• Adjust the Automatic Gain Control for each camera.
• Disable or enable individual camera inputs.
• Specify cameras as covert (recorded but not displayed).
• View the camera scope (histogram).
• Specify Monitor B to be a SVHS (Y/C) output.
• Specify public display monitors.
Camera Titles
Select this item to display the Camera Titles sub-menu. From this sub-menu, the user can:
• Specify which monitors will display camera titles.
• Edit the title for each camera.
MDR Series Multiplexer Digital Recorders
'MENU'
: Exit activity setup
'ENTER' : Save and exit activity setup
'PAUSE' : Toggle between Enable and Neutral
{F}
'STOP'
: Toggle between Disable and Neutral
'ZOOM'
: Disable/Enable all zones
'PLAY FORWARD' : Increase the Sensitivity level
'PLAY REVERSE' : Decrease the Sensitivity level
MOTION DETECTION
CAMERA SETUP
Page 41
Advertisement
Table of Contents
