Advertisement
B20F/B20F-PG/B30F/B30F-PG Mixer Parts List
WARNING AND SPECIAL ATTENTION
WARNING
1 DON'T USE WATER PIPE TO WASH THE MIXER DIRECTLY;
2 PLEASE PULL OFF THE PLUG BEFORE MAINTAINNING, AND MAKE IT
MAINTAINED BY PROFESSIONALS;
3 DON'T TOUCH THE SWITCHSAND PLUG WITH WET HAND;
4 IF BROKEN, PLEASE STOP USINGAT ONCE
5 THERE ISAGROUNDED NUT (SIGNED "
RECOVER IT TO ORIGIN CONDITION, DON'T CANCELTHE GROUNDED LINE;
6 DON'T PUT HANDS INTO THE BOWL OR TOUCH THE MIXING DEVICES WH-
EN WORKING;
7 DON'TALLOW THE MINOR CLOSE TO THE MACHINE;
8 THE MACHINE SHOULD BE FIXED ON THE DRYWOODEN SPLINTAND WO-
RK IN SAFEAREA;
9 IF THE ELECTRICALWIRE IS BROKEN, PLEASE CHANGE IT BY PROFECTIO-
NALS.
SPECIAL ATTENTION
1 BEFORE USING , PLEASE CLEAN THE BOWLAND THE MIXING DEVICES CAR-
EFULLY,AND THEN INSTALLTHE BOWL ONTO THE MACHINE CORRECTLY
AND TIGHTLY;
2 WHEN CHOOSING MIXING DEVICES, PLEASE REFER TO THE OPERATION MA-
NUALTO CHOSE THE CORRECT SPEED, OR IT WILL DESTORYTHE INSIDE SPA-
RE PARTSAND SHORTEN THE USING LIFE OF THE MACHIE;
3 AFTER USING, PLEASE POWER OFF THE MACHINE,AND PUT THE BOWLAND
DEVICES IN THE SAFEAND CLEAN PLACEAFTER CLEANING;
4 KEEP ENVIROMENTARROUND THE MACHINE DRY HEALTHAND SAFE.
In order to keep safety, when using Mixing device
grooves which are from the handles into the spiral axle pin separately. Furthermore, rising
bowl to the highest positon, so that the edge of the bowl is higher than Mixing device
working position.
") IN THE MACHINE, PLEASE
I/II/III
, Please pay attention to insert their
I/II/III
13
B20F/B20F-PG/B30F/B30F-PG Mixer Parts List
Figure 1 TRANSMISSION CASE
1
9
3
10
11
4
5
6
7
cover (4)
cover (10)
the
Item
1
2
3
2
4
5
6
7
8
9
10
12
11
8
12
NOTES
Machine at a factory hour have added to
note the superior quality lubricates the
grease, usually the circumstance bottom
can use for several years, but machine is
after maintaining, must replace the lubri-
cation grease.
Fill with the lubrication grease empress,
please the cover the tight noting the oil b-
ore cover.
2
Qty
Descviption
screw M6*45
1
1
cover
4
screw M5*8
1
cover
2
bearing 6201
4
screw M6*25
1
end cover
body
1
screw M5*8
3
1
cover
1
bearing 6003
1
rear cover
Advertisement
