Download Print this page
KingsBottle KBU-25S SERIES User Manual

KingsBottle KBU-25S SERIES User Manual

Compressor wine cellar kbu-25s series

Advertisement

Quick Links

USER MANUAL
KBU-25S SERIES
LAE controller from Italy
COMPRESSOR WINE CELLAR
www.kingsbottle.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the KBU-25S SERIES and is the answer not in the manual?

Questions and answers

Summary of Contents for KingsBottle KBU-25S SERIES

  • Page 1 USER MANUAL KBU-25S SERIES LAE controller from Italy COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 2 CHAPTER CONTENTS PAGE Congratulations and thank you for choosing our KingsBottle Wine Cellars . We are sure Part I Important Safety & Pre-Use Instructions you will find your new appliance a pleasure to use . Before you installing and operating...
  • Page 3 Don’t put the refrigerator in frosty or unprotected areas like a garage or on the verandah. www.kingsbottle.com in the built-in structure, clear of obstruction. Keep the refrigerator out of direct sunlight.
  • Page 4 YOUR WINE CELLAR ALSO INCLUDES THE FOLLOWING: • Instruction manual • Two keys • Top and bottom hinges , also screws for changing the door hinge Note: Above diagram and description is for SINGLE ZONE WINE CELLAR MODELS: KBU-25S series www.kingsbottle.com...
  • Page 5 INSTALLATION PART III INSTALLATION INSTRUCTIONS CUTOUT DIMENSION ILLUSTRATED KBU-25S SERIES 15.01”W x 24.03”D x 34.87”H ( 381W x 610D x 885H mm ) Included stand height 0.98” (25mm) MODEL WIDTH DEPTH HEIGHT INCLUDED NOTE STAND HEIGHT KBU-25S 15.01” 24.03” 34.87”...
  • Page 6 Step 1 Take out the handle from the cellar and remove the plastic bag, also remember 2pcs of screw are packed inside. Step 2 Pull out a bit of rubber gasket from the back side of the hole. Step 3 Insert the screw through the hole and connect with the handle www.kingsbottle.com...
  • Page 7 1.5” for each side, specially consider the air flow exchange at the rear side. Also need to consider door swing, etc. Failure to allow minimum clearance will void all warranties. Failure to allow minimum clearances will void all warranties COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 8 Don’t put the refrigerator in frosty or unprotected areas like a garage or on the verandah. Keep the refrigerator out of direct sunlight. www.kingsbottle.com Meanings of symbols used in this manual are shown below: Don’t locate the refrigerator near stoves, fires or heaters.
  • Page 9 • Before you begin to reverse the door, it is recommended to tape down shelves to avoid movement during the process • It is recommended to take out the wine bottles from the cellar before reversing the door COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 10 This unit comes with an optional key lock. The keys are located inside the plastic bag that contains the user manual. To unlock the door, insert the key into the lock and turn counterclockwise. To lock the door, simply reverse the operation making sure the metal pin is engaged completely. Then remove the key and place it is a secure place for safekeeping. www.kingsbottle.com...
  • Page 11 DO Door open alarm INFO MENU The information available in this menu is: T1 Instant probe 1 temperature Minimum probe 1 temperature recorded T2 Instant probe 2 temperature Compressor working weeks Maximum probe 1 temperature Keypad state lock recorded COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 12 By keeping button pressed, use button to set the desired value. When button is released, the newly programmed value is stored and the following parameter is displayed. • • To exit from the setup, press button or wait for 30 seconds. www.kingsbottle.com...
  • Page 13 Fan stop delay after compressor stop. See Fig. 2. 0...30min Timed fan stop. With FT2=0 the fans remain on all the time. 0...30min Timed fan run. With FT3=0, and FT2 > 0, the fans remain off all the time. COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 14 ST1, the probes must be the LAE models ST1... -12.5..12.5°C Probe T1 offset. NO/YES Probe T2 enabling (evaporator). -12.5..12.5°C Probe T2 offset. 1...30 min Delay for minimum temperature (TLO) and maximum temperature (THI) logging. 0...100 Display slowdown. 1...255 AD3-5 address for PC communication. www.kingsbottle.com...
  • Page 15 When you use the wine cellar. for the first time or restart the wine cellar after having been shut off for a long time, there will be a few degrees variance between the temperature you select and the one indicated on the LED readout for the first few hours of operation. After a few hours of operation, the temperature will normalize to the displayed temperature. www.kingsbottle.com...
  • Page 16 KBU-25S storage • Each rolling shelf is designed to hold one row of 3 to 6 bottles. PLEASE NOTE Before modifying your cabinet’s original configuration in any way, be sure to ask your dealer for advice. COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 17 COMPRESSOR WINE CELLAR accelerate the defrosting process, other than those recommended by the manufacturer. per 8g of refrigerant. The amount of refrigerant charged in the appliance can be found on the rating plate on www.kingsbottle.com the appliance.
  • Page 18: Technical Data

    32 - 100 °F TEMPERATURE RANGE 41-64 °F NET WEIGHT 92 lbs (42 KGS) GROSS WEIGHT 99 lbs (45 KGS) 15.01”W x 24.03”D x 34.87”H DIMENSION ( 381W x 610D x 885H mm ) Included stand height 0.98” (25mm) www.kingsbottle.com...
  • Page 19 NOTES COMPRESSOR WINE CELLAR www.kingsbottle.com...
  • Page 20 Limited warranty – 90 day replacement plan with a free 9 months upgrade, totaling 1 year, on parts and labor from the date of shipment. For customer service, please contact BTO AMERICA LIMITED by e-mail ( service@kingsbottle.com) The limited warranty does not cover: Damage due to such things as accident, misuse, abuse, mishandling, neglect, unauthorized repair or any other cause beyond the control of the seller whether similar or dissimilar to the foregoing.

This manual is also suitable for:

Kbu-50sKbu-170sKbu-120s