2
Quick Start Instructions
Fielding the Camera (Run Mode)
Step.1:.Install.Six.D-Cell.Alkaline.Batteries ..(Recommend.Duracell™)
Step.2:.Install.Compact.Flash.Card:.With.the.power.switch.in.the.off.position,.install.
the.compact.flash.memory.card.with.the.label.on.top.and.pointed.to.the.right ...
The.compact.flash.must.be.properly.installed.in.order.for.the.camera.to.
operate ..Neverforce.the.memory.card.into.the.slot .
Step.3:.Place.camera.in.setup.mode.using.the.toggle.switch .
Step.4:.Observe.messages.on.LCD.display.(version/time/date/etc) .
Step.5:.Perform.walk-test .
Step.6:.Turn.camera.off.and.wait.3-seconds .
Step.7:.Turn.camera.to.run.mode.using.the.toggle.switch .
Step.8:.Observe.the.status.messages.on.the.LCD ..This.is.followed.by.the.count-
down.blinking.of.the.green.LED.located.behind.the.PIR.lens ..There.will.be.
approximately.1-minute.to.close.the.unit.and.leave.the.area .
Retrieving the Camera (Setup Mode)
Step.1:.When.returning.to.the.scouting.area,.open.the.camera.and.wait.for.the.busy.
LED.to.go.off ..Turn.the.camera.off.using.the.toggle.switch ..Wait.3-seconds.
before.entering.setup.mode .
NOTE:
(Compact Flash Card) The compact flash card should only be removed while the Mode Switch
in the OFF position. Do not remove the flash card while the keypad "BUSY" LED is on, this may
corrupt the flash card.
Step.2:.Turn.the.camera.to.the.setup.mode ..One.of.the.display.messages.will.indicate.
the.number.of.stored.pictures ..View.the.images.using.the.video.port .
Step.3:.Turn.the.camera.off.when.finished .
3
Figure – 1
Figure – 2
External and Internal Views - Figure 1-2
4